Charging; Operation - Silvercrest SAS 7.4 LI B2 Bedienungsanleitung

Charging

NOTE
Check to ensure that the on/off switch 6 has been pushed back (to the
►
position "0 ) before starting the charging process.
Place the handheld vacuum cleaner from above into the wall bracket 3 so
■
that the barrel plug 5 slips into the socket on the handheld vacuum cleaner.
The charge indicator lamp 7 lights up red and the charging process begins.
Important: The charge indicator lamp 7 lights up green once the handheld
■
vacuum cleaner is charged enough to vacuum again. This does not mean that
all the batteries are completely charged. When the charge indicator lamp 7
lights up green, the batteries are charged to around 80%.
■ When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function). Nevertheless, in order to avoid possible damage
to the batteries, do not leave the appliance permanently connected to the
mains adapter 4.
■ Do not recharge the batteries again until the handheld vacuum cleaner's
suction power becomes appreciably weaker and the charge indicator lamp 7
fl ashes green.
NOTE
► The handheld vacuum cleaner can also be charged directly via the mains
adapter 4. To do this, remove the barrel plug 5 with a slight twist from the
wall bracket 3 and insert it into the socket on the handheld vacuum cleaner.

Operation

CAUTION!
► The suction opening must always be open and may not be blocked. Block-
ages lead to overheating and damage to the motor.
NOTICES
Make certain that the dust fi lter 0 is always inserted before using the
►
appliance.
When vacuuming liquid, do not exceed the MAX marking in dirt container q.
►
│ GB │ MT
■ 32 SAS 7.4 LI B2