Auxiliary Handle; Changing The Tool - Bosch PSB 650 RE Originalbetriebsanleitung

24 | English
Reattach the dust collector 12 again and lock it
by pressing against the smooth surface of the
release button 15.
Removing the Extraction Device (see figure E)
For disassembly of the extraction device 11,
press release button 19 and pull off the extrac-
tion device 11 toward the front.
Stowing the Extraction Device (see figure F)
For stowing the extraction device 11 in the case,
remove the extraction device 11, slide it togeth-
er and attach clamp 20.
Attach the locking latch 21 or empty the dust
collector 12 before placing down the extraction
device.

Auxiliary Handle

Operate your machine only with the auxilia-
ry handle 9.
The auxiliary handle 9 can be set to any position
for a secure and low-fatigue working posture.
Turn the wing bolt for adjustment of the auxilia-
ry handle 10 in anticlockwise direction and set
the auxiliary handle 9 to the required position.
Then tighten the wing bolt 10 again in clockwise
direction.
Adjusting the Drilling Depth (see figure G)
The required drilling depth X can be set with the
depth stop 1.
Press the button for the depth stop adjustment
3 and insert the depth stop into the auxiliary
handle 9.
The knurled surface of the depth stop 1 must
face downward.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth X.
2 609 004 159 | (7.9.09)

Changing the Tool

Keyless Chuck (PSB 750 RCE/PSB 750 RCA)
(see figure H)
The drill spindle is locked when the On/Off
switch 8 is not pressed. This makes quick, con-
venient and easy changing of the tool in the drill
chuck possible.
Open the keyless chuck 2 by turning in rotation
direction , until the tool can be inserted. Insert
the tool.
Firmly tighten the collar of the keyless chuck 2
by hand in rotation direction
action ("click") is no longer heard. This automat-
ically locks the chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direc-
tion.
Keyless Chuck (PSB 650 RE/PSB 6500 RE/
PSB 650 RA) (see figure I)
Press the spindle lock button 24 only when
the machine is at a standstill.
The drill spindle is locked by pressing the spin-
dle lock button 24. This makes quick and easy
changing of the tool in the drill chuck possible.
Open the keyless chuck 2 by turning in rotation
direction , until the tool can be inserted. Insert
the tool.
Firmly tighten the collar of the keyless chuck 2
by hand in rotation direction
action ("click") is no longer heard. This automat-
ically locks the chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direc-
tion.
Screwdriver Tools
When working with screwdriver bits 23, a uni-
versal bit holder 22 should always be used. Use
only screwdriver bits that fit the screw head.
For driving screws, always position the "Drill-
ing/Impact Drilling" selector switch 4 to the
"Drilling" symbol.
until the locking
until the locking
Bosch Power Tools