HQ Power VDPC145 Bedienungsanleitung Seite 4

7. LED Display
Displays all necessary information
8. Bank Buttons
Press ▲ or ▼ to select a bank. The third and fourth digit on the LED display make up the bank
number (01 – 30).
9. Chase (1 – 6)
Press a button to run or store a chase. The first digit on the LED display is the chase number (1 – 6).
10. Program
The device is in MANUAL RUN mode when you turn it on. Hold the PROGRAM button for 2 seconds.
The LED flashes and SCENE and CHASE are ready to be programmed. Hold PROGRAM for 2
seconds again to activate the BLACKOUT mode. The PROGRAM LED extinguishes and the
BLACKOUT indication is lit. Press the BLACKOUT button to return to the MANUAL RUN mode. The
blackout LED goes out.
11. MIDI / ADD
MIDI : Hold the MIDI button for two seconds when the device is in RUN mode. The third and fourth
ADD : Push this button to add lines in a program while the device is in the programming mode.
12. AUTO / DEL
AUTO : Press this button while the device is in the RUN mode. The AUTO TRIGGER LED is lit,
DEL
13. MUSIC / BANK COPY
MUSIC
BANK COPY
14. TAP SYNC / DISPLAY
TAP SYNC
DISPLAY
15. BLACKOUT
Press this button to set the output of all channels to 0%. This does NOT affect the other functions of
the device. Press this button again to deactivate the blackout mode.
b) Back Panel
16. MIDI IN
17. DMX POLARITY SELECT
18. DMX OUT (3-pole XLR)
19. DC input (9-12V, 300mA)
VDPC145_v2
digit of the LED display start to flash. Select a MIDI channel with ▲ or ▼. Press any button
other than ▲ or ▼ to end the MIDI channel setting.
indicating that the AUTO RUN mode has been activated. Press the AUTO button again to
deactivate the auto run mode.
: Push this button to delete a scene or a chase while in the programming mode.
: Push this button while in the device is in RUN mode. The MUSIC mode is now
activated and the MUSIC TRIGGER LED is lit. Press this button again to
deactivate the MUSIC mode.
: Press this button to copy a bank when the device is in the programming mode.
: When the device is in the AUTO RUN mode, the running speed depends on the
duration of the interval between the last two times you pressed the TAP
SYNC/DISPLAY button.
: Press this button to choose between 00-255 or 0%-100% display for the faders.
Fig. 2
4 VELLEMAN