Operating Instructions; Design And Function; Main Parts; Signs And Stickers On The Machine - Chicago Pneumatic PAC P 18 Sicherheitshinweise Und Betriebsanleitung

PAC P 18
OPERATINg
INSTRUCTIONS
To reduce the risk of serious injury or death
to yourself or others, before operating
the machine, read the Safety instructions
section found on the previous pages of this
booklet.

Design and function

The Chicago Pneumatic PAC P 18 is a hydraulic
power pack designed for operating Chicago
Pneumatic hydraulic breakers and other work
tools. The power pack is fitted with an 18 HP
Briggs & Stratton Vanguard V-Twin air cooled
petrol engine. On the PAC P 18 power pack, the oil
flow can be adjusted continuously between 20-38
l.p.m. (5-10 US gal/min)
Note! The torque of the engine is reduced
when reducing the rpm. The power pack
can therefore not in all cases deliver the
maximum pressure at low rpm.

Main parts

1. Filler cap, fuel
2. Filler cap, hydraulic oil
3. Sight glass, hydraulic oil level
4. Filter condition gauge
5. Hydraulic oil filter
6. Engine oil, dipstick
7. Ignition switch OFF and ON
339 5184 83
Safety and operating instructions
8. Fuel tap
9. Oil cooler
10. Hydraulic pump
11. Choke control
12. Recoil start
13. Pressure relief valve
14. Throttle lever
15 Foldable handle
16. By-pass valve
17. Air filter
18. Drain plug
19. Battery
20. Engine oil filter
Signs and stickers on the
machine
Signs and stickers with important information
about personal safety and machine care are
mounted on the machine. The signs and stickers
must always be legible. New signs and stickers can
be ordered from the spare parts list.

Data plate

The data plate contains the following important
information:
1. Maximum permitted hydraulic oil flow.
2. Machine type.
3. Maximum permitted hydraulic pressure.
9