Polaris 360 Benutzerhandbuch Seite 2

Important Information
• Before installing the Polaris, make sure the pool filter is clean.
• New plumbing lines should be flushed out before installing the Polaris.
• The Polaris should not be used to remove plaster dust in new pools.
• Except when checking the wheel RPM, do not handle the Polaris while it is operating.
• Always remove the Polaris before swimmers enter the pool.
• Always disconnect the Polaris from the pool wall when cleaning or backwashing the pool filter.
• Always remove the Polaris from the pool before chemical shock treatments.
• After cleaning or backwashing, let the filtration system run for at least five minutes before re-connecting the Polaris.
• Solar heating systems, ozone generators, and other air inducing equipment may cause air flow through the cleaner,
adversely affecting cleaner balance and performance. Plumb the dedicated cleaner line upstream of these compenents.
• Highly chlorinated water can cause maintenance problems. Avoid running Polaris while chlorinating.
For customer service or support:
• Please mail Warranty Card immediately.
• For on-line support:
• To contact Polaris:
WARNING: USE OF POLARIS 360 IN A VINYL LINER POOL
Certain vinyl liner patterns are particularly susceptible to rapid surface wear or pattern removal caused by objects coming
into contact with the vinyl surface, including pool brushes, pool toys, floats, fountains, chlorine dispensers, and automatic
pool cleaners. Some vinyl liner patterns can be seriously scratched or abraded simply by rubbing the surface with a pool
brush. Ink from the pattern can also rub off during the installation process or when it comes into contact with objects in
the pool. Zodiac Pool Systems, Inc., is not responsible for, and the Limited Warranty does not cover, pattern removal,
abrasion or markings on vinyl liners.
www.polarispool.com
US and Canada
Customer Service
2620 Commerce Way
Vista, CA 92881-8438
1-800-822-7933
www.polarispool.com