Tips And Notes; Maintenance And Cleaning; Technical Data - Conrad 809340 Bedienungsanleitung

Tips and notes

a) USB 3.0
• USB 3.0 devices are downwardly compatible. That means that the product with the installed
hard drive can also be connected to common USB 2.0 ports or slow USB 1.1 ports. The
transfer speed will be reduced accordingly, though.
• Ideally, USB 3.0 makes speeds of over 100 Mbyte/s possible depending on your computer's
hard drive, the hard drive mounted in the casing, and the USB 3.0 controller.
• Using a common USB 2.0/1.1 cable instead of the included USB 3.0 cable will reduce the
transfer rate.
• If you want to connect the product via a USB hub, the USB hub has to support USB 3.0 for
the maximum transfer rate to be possible.
b) General
• When turning on the hard drive case, the blue LED lights up. The LED starts flashing when
reading/writing operations access the hard drive.
• If the connection cable is disconnected during data transmission, files could be damaged
or the operating system could shutdown. First safely remove the hard drive through the
operating system before disconnecting the connection cable.
• Always handle hard drives very carefully. Impacts during operation and even for several
seconds after switching off the product can cause the reading/writing heads to touch the
magnetic discs, which in turn could damage the hard drive.
• When connecting the hard drive for the first time, it could take approx. one minute for the
hard drive to be recognized. The length of this time period varies depending on the operating
system.

Maintenance and cleaning

Do not use any aggressive cleaning agents as these may lead to discoloration.
To prevent scratch marks, do not apply too much force on the surface during
cleaning.
• Disconnect the product from the operating system before cleaning. Wait for at least
30 seconds until all magnetic discs have come to a complete stop. Disconnect the
USB Y cable from the product.
• Besides occasional cleaning, the device is maintenance-free. To clean the device, use a soft,
anti-static and lint-free cloth.
• You can use a clean, long-haired brush and a vacuum cleaner to easily remove any dust.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household
waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

Technical data

Operating voltage ...................... 5 V/DC
System requirements . ................ W indows® ME, 2000
................................................... X P (Home, Pro, with SP1, SP2, SP3, only 32 bit)
................................................... V ista™ (32/64 bit), 7 (32/64 bit), 8, 8 Pro
................................................... E nterprise 7, Enterprise 8
................................................... R T
................................................... M ac OS 9.x and higher
................................................... L inux 2.4.x and higher
Suitable for ................................ 6 .35 cm (2.5") SATA hard drive, height 7 mm / 9.5 mm
USB standard ............................ U SB 3.0 (downward compatible to USB 2.0/1.1)
Hard drive capacity . ................... m ax. 2 TB
USB cable length . ...................... a pprox. 54 cm
Operating conditions . ................. + 5 to +40 ºC, 5 – 90 % RH (non-condensing)
Storage conditions . .................... - 20 to +70 ºC, 5 – 90 % RH (non-condensing)
Dimensions (W x H x D) ............ 1 30 x 12 x 78 mm
Weight ....................................... 2 00 g
These operating instructions are published by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2014 by Conrad Electronic SE. V1_0214_02-ETS-Mkde