Basic Configuration - Audio Pro LIVING LV33 Bedienungsanleitung

BASIC CONFIGURATION

MAC/PC
Before connecting to computer, see Mac or PC setup.
1. Connect the TXD200 transmitter to the computer.
2. Connect both LV33 speakers to 230V outlet.
Done! Play your music on your computer.
WIRELESS STATUS:
LED lights up blue on speakers and transmitters when wireless connection is established.
LED lights up red on speakers and transmitters when no wireless connection is established.
LED lights up green on speakers and transmitters when paired wireless connection is established.
Note:
- Make sure that both speakers and transmitter are using same House Code (channel 1, 2 or 3).
- If speakers are in automatic standby mode, LED is red even though wireless connection is
established. Turns blue when speakers receives audio signal.
MAC SETUP
1. Connect TXD200 transmitter to a free USB socket.
2. Go to System Preferences, choose Sound under Hardware.
3. Click Output in menu, choose "USB Headset".
Done! You can now send audio from your computer.
PC SETUP
Please do following setup before using music playing software (for example iTunes or Spotify).
1. Connect TXD200 transmitter to a free USB socket. Wait until software has been installed.
(See lower right hand corner, message window will open when sound device is ready to use.)
Done! You can now send audio from your computer.
For some PC computers ( i e Windows 7) you may need to perform these settings:
2. Click Start button, go to Control Panel and choose Sound & Sound devices.
3. Under playback of audio, default unit, choose "USB Headset".
Done! You can now send audio from your computer.
6
PAIRING LV33 SPEAKERS WITH TRANSMITTER
By pairing, you lock your Audio Pro network from other peoples Audio
Pro Wireless networks. In unpaired mode, the TXD200 and LV33 will work
with all Audio Pro Living wireless products.
PAIR YOUR LV33 SPEAKERS WITH TXD200 TRANSMITTER
1. Press Pairing button on transmitter for 2 seconds. LED starts to flash
Green.
2. Press and hold ZONE/PAIR button on LV33 speaker for 3 seconds.
(Lift of cloth grille to access buttons.) LED starts to flash Green.
3. When LEDs on both transmitter and speaker goes to steady green, the
system is paired.
Note:
1. Pairing will not work with older Living speakers.
2. To unpair system (all speakers in same volume zone will be unpaired):
- Disconnect TXD200 from power.
- While pressing the pairing button, reconnect TXD200 to power, and hold pairing button for
6 seconds.
3. On LV33 speaker; turn speaker off with main switch on rear panel. While turning the
speaker on again, hold the House Code button pressed.
The transmitter and speakers will now be unpaired.
PLAY WIRELESS FROM OTHER SOUND SOURCES
The TXD200 transmitter has a combined analog/optical sound input on its end. You can connect
any device with sound output, optical or analog, to the transmitter. Computer, mp3-player, iPod/
iPhone/iPad dock, cellphone, stereo/receiver, cd-player, radio, etc. TXD200 contains an advanced
Burr-Brown A/D converter for best sound reproduction. The transmitter TXD200 must be powered
by Audio Pro USB power adaptor if connected by cable (sold separately).
Connect any device with sound output, optical or analog.
Examples:
iPod/iPhone/iPad dock
Apple TV, Airport Express
Cellphone
CD-player
Network player
To 230V
AC outlet
Stereo/receiver
TV
Sat/Cable receiver
Optical or
analog cable
7