Reset - Conrad FCT3b Anleitung Für Montage Und Betrieb

now, conduct the function test. If it fails, repeat the action.
6 .
NOTE:
If the "bell/light" key is released before the above-mentioned 4 seconds have
elapsed, the learning process is terminated; this is indicated by three short light sig-
nals. The existing radio code is then retained.
6

Reset

Resetting the device causes the following to occur:
• All access codes are reset.
• all radio code locations are uniquely assigned again.
In order to perform a reset:
1 . Remove the battery.
2 . Wait approx. 10 seconds.
3 . push the 0 key and simultaneously replace the battery, holding the 0 button for
at least 5 seconds.
The following light signals are emitted:
– slow flashing for approx. 1 second
– rapid flashing for approx. 4 seconds
– extremely rapid-flashing for approx. 2 seconds
4 . Release the 0 key.
The device is now in the normal operating mode again.
NOTE:
If the "0" key is released before the above-mentioned 5 seconds have elapsed, the
reset procedure is terminated and three short light signals are emitted. The device
is now in the normal operating mode again. The existing access codes and radio
codes are then retained.
TR20A004-C / 08.2009
ENGLISH
17