Direct Function Of The "Bell/Light" Key; Transmitting Via The "Bell/Light" Key; Learning Via The "Bell/Light" Key - Conrad FCT3b Anleitung Für Montage Und Betrieb

ENGLISH
5 .2

Direct function of the "bell/light" key

During normal operation the "bell/light" key has a special status – you can use it to
transmit directly, i .e . without having to enter an access code, in the same way
as transmitting and learning using a hand transmitter. Furthermore, your radio code
can be recoded by resetting.
Within the operating functions this direct function is nearly always active, i.e. also
when an access code is being entered, provided that no other key is being
pressed, no transmission is being made to another radio code location and no
transmitting or learning is in progress.
An exception is the 20-second phase, in which the same radio code can be
repeatedly transmitted without a new access code having to be entered, because
for the premature termination of this phase the "bell/light" key is needed. During this
20-second phase, the direct function of the "bell/light" key is therefore deactivated.
5 .2 .1

Transmitting via the "bell/light" key

press the bell/light key.
f
a long light signal is emitted and the corresponding radio code is transmitted
(light signal flashes rapidly).
NOTE:
as long as the "bell/light" button is pressed, the radio code is transmitted, but for a
maximum of 15 seconds.
5 .2 .2

Learning via the "bell/light" key

Uncontrolled door travel
During the learning process, activation of the teaching transmitter can initiate a
door travel if a receiver programmed for it is located nearby!
Please ensure that no persons or objects are within the danger area of the
f
door during the learning process.
1 . Hold the teaching transmitter close to the code modulator, as shown, and then
press and hold the desired key, of which the radio code is to be learned. (see
Figure 2)
2 . press and hold the
A long light signal is emitted.
3 . If the signal received from the teaching transmitter is strong enough, after
approx. 0.5 seconds a rapid-flashing light signal is emitted for approx. 4
seconds to indicate that the signal can be learned.
4 . Press the key until the end of these 4 seconds.
after successfully completing the learning process, a long light signal is emitted.
Release the keys of both the teaching transmitter and the FCT3b.
5 .
16
CAUTION
bell/light key.
TR20A004-C / 08.2009