Herunterladen Inhalt Inhalt Diese Seite drucken

Light/Flashing Signals; Changing The Access Codes - Conrad FCT3b Anleitung Für Montage Und Betrieb

Funk-codetaster
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
Radio code location
a memory location for a radio code that, similar to the hand transmitter, can be
transmitted, learned and recoded.
a total of 4 radio code locations are available in the device:
three radio code locations that can be accessed using the access code
another radio code location that is directly accessible (without the access code)
Radio code
The 1 billion security code, which in the ex-factory settings or after a reset is uni-
quely pre-assigned to all the radio code locations.
4

Light/flashing signals

How the leD glows varies, depending on the operating state:
short light signal (Fig.
long light signal (Fig.
slow-flashing (Fig.
rapid-flashing (Fig.
extremely rapid-flashing (Fig.
5

Changing the access codes

When changing the access code, it is assumed that the normal transmission times
(Chapter 5 .1) have elapsed. This is always indicated by a long light signal.
If in any doubt about this, wait more than 20 seconds without pressing any key
f
before making an entry.
NOTE:
every permitted press of a key is acknowledged by a short light signal; this also
enables you to monitor whether the key was actually pressed. Furthermore, when
two keys are pressed in succession, the time between pressing the first key and the
second may not exceed 15 seconds; otherwise a long light signal is emitted and
you can/must then start afresh. In this way (simply wait for a long light signal) any
action initiated incorrectly or by mistake can be terminated and you can then start
again.
an invalid or incorrect entry is always indicated by three short light signals, after
which the unit completely deactivates itself for 10 seconds and you then have to
wait for a long light signal before starting the action again.
In the ex-factory settings or after a reset, the factory access code is assigned to all
three memory locations (numbered 1 to 3). These access codes should be
changed as follows (Fig. 4):
TR20A004-C / 08.2009
3a)
3b)
3c)
3d)
3e)
ENGLISH
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis