Carson Combo DRAGSTER 3 Betriebsanleitung Seite 15

Programmable items list
Item
1. Running Mode
2. Drag BrakeForce
3. Low Voltage Cut-Off
Threshold
4. Start Mode(Punch)
5. Maximum BrakeForce
6. BEC voltage
Attention: the gray shaded texts in the above form are the default settings.
1). Running Mode:
With "Racing" mode, the car can go forward and brake, but cannot
go backward, this mode is suitable for competition; "General"
mode provides backward function, which is suitable for training.
The "Rock Crawler" mode is only used for rock crawler.
note: "general" mode uses "Double-click" method to make the
car go backward.
When you move the throttle stick from forward zone to backward
zone for the first time, the ESC begins to brake the motor, the
motor speeds down but it is still running, not completely stopped,
so the backward action is NOT happened now. When the throttle
stick is moved to the backward zone again (The 2nd "click"), if the
motor speed is slowed down to zero (i.e. stopped), the backward
action will be occurred. The "Double-Click" method can prevent
mistakenly reverse when the brake function is frequently used in
steering.
2). Drag Brake Force:
Set the amount of drag brake applied at neutral throttle to simulate
the slight braking effect of a neutral brushed motor while coasting.
3). Low Voltage Cut-Off:
The function is mainly to prevent the lithium battery pack from
over discharging. When using lithium battery pack, please set the
suitable value for low-voltage protection as your like. The ESC
monitors the battery's voltage at any time, if the voltage is lower
than the threshold, the output power will be reduced to 50% in
2 seconds. Please drive and stop the car at the side of the racing
track as soon as possible, the ESC will completely cut off the output
power in 10 seconds.
4). Start Mode (Also called "Punch"):
Select from "Level 1 (Soft)" to "Level 4 (Very aggressive)".
If the motor cannot run smoothly (the motor is trembling), it may
Reset All items to Default Values
At any time when the throttle is located in neutral zone (except in
the throttle calibration or parameters program process), hold the
1 2
Racing General
0% 5% 10%
Non-Pro- 2.6V/Cell 2.8V/Cell
tection
Level 1 soft Level 2 Level 3
25% 50% 75%
6,0V 7,4V
Programmable Value
3 4 5
15% 20%
3.0V/Cell 3.2V/Cell
Level 4
100%
caused by the weak discharge ability of the battery pack, please
choose a better battery or increase the gear rate.
5). Maximum Brake Force:
The ESC provides proportional brake function. The brake force is
related to the position of the throttle stick. Maximum brake force
refers to the force when the throttle stick is located at the top point
of the backward zone. A very large brake force can shorten the
brake time, but it may damage the gears.
6). BEC voltage
option 1: 6.0V
Only use conventional standard servos (6V) with this setting.
option 2: 7.4V
Only high voltage servos should be used with this setting.
"SET" key for over 3 seconds, the red LED and green LED will flash at
the same time , which means each programmable item has be reset
to its default value.
6 7 8
25% 30% 40%
3.4V/Cell
15 // GB