Riester ri-medic Gebrauchsanweisung Seite 10

4.1 ICONS AND CUES
Your Riester ri-medic is designed to provide unambiguous visual and auditory cues before, during and after a measurement. For
easy reference, all cues are tabulated in this chapter.
Audible cues, or beeps, identify stages in the measurement cycle.
Icons illuminated within a module's display indicate measurement modes, processes or warnings.
a.) Auditory Cues
The BP modules of the Riester ri-medic are programmed with auditory cues. A listing of these cues appears below.
NUMBER OF BEEPS...
One short beep after power up or right
before powering down
One short beep after
taking a measurement
Three short beeps
Three long beeps
One short beep followed
by a long beep
b.) Visual Cues - Battery Icon
If your Riester ri-medic does not have a battery, all segments of the battery icon are lit when the power supply is connected.
If your device has a battery, then the icon indicates the status of the power supply as follows.
ICON/DISPLAY
10
INDICATES...
The device is powered up and
ready use or the device is
about to turn off.
Success – measurement
taken.
BP measurement error.
Please check or take another
measurement.
A system error has occurred.
Please refer to page 18 for
troubleshooting.
You have aborted this BP
measurement.
INDICATES...
Battery fully charged
Battery is charging (segments animated)
Power-off state
As the charge level drops, the segments
will be turned off in sequence from the
right to the left.
The battery charge is very low. Recharge
before using. (segment flashing)