Philips FastCare Compact GC6704 Gebrauchsanleitung Seite 22

22 ENGLISH
Problem
Water flushes
out of the
soleplate.
The Calc-Clean
process does
not start.
The ironing
board cover
becomes wet, or
there are water
droplets on the
floor/garment.
Possible cause
Steam condenses
into water in the hose
when you use steam
for the first time or
have not used it for a
long time.
You have accidentally
started the Calc-
Clean process (see
chapter 'Cleaning and
maintenance').
You have not pressed
the CALC-CLEAN
button for 2 seconds
until the appliance
started beeping.
Steam has condensed
on the ironing board
cover after a long
ironing session.
You have an ironing
board that is not
designed to cope with
the high steam rate of
the appliance.
Solution
This is normal. Hold
the iron away from
the garment and press
the steam trigger. Wait
until steam instead of
water comes out of
the soleplate.
Switch off the
appliance. Then switch
it back on again. Let
the iron heat up until
the 'iron ready' light
lights up steadily.
See chapter 'Cleaning
and maintenance'.
Replace the ironing
board cover if the
foam or felt material
has worn out. You can
also add an extra layer
of felt material under
the ironing board
cover to prevent
condensation on the
ironing board.
Put an extra layer of
felt material under the
ironing board cover to
prevent condensation
on the ironing board.