Philips FastCare Compact GC6704 Gebrauchsanleitung Seite 20

20 ENGLISH
Problem
The light of
the CALC-
CLEAN button
flashes and the
appliance beeps.
No steam
comes out of
the soleplate,
the light of
the CALC-
CLEAN button
flashes and the
appliance beeps.
The appliance
has switched off.
Possible cause
At the start of your
ironing session, the
steam trigger has not
been pressed long
enough.
You have set the
temperature dial to ●.
This is the Calc-Clean
reminder.
You have not done or
have not completed
the Calc-Clean
process.
The auto shut-off
function is activated
automatically. The
appliance enters the
standy mode if it has
not been used for 15
minutes and switches
off if it has not been
used for another 10
minutes.
Solution
Press and hold the
steam trigger until
steam comes out. It
may take up to 30
seconds until steam
comes out.
Steam is not available
at ●. To use the steam,
set the temperature
dial to ●● or higher.
Perform the Calc-
Clean after the Calc-
Clean reminder is
given (see chapter
'Cleaning and
maintenance').
Perform the Calc-
Clean process to
enable the steam
function again (see
chapter 'Cleaning and
maintenance').
To switch on the
appliance again, set
the on/off switch to
"off" position and then
to "on" position.