Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manual
4. Information
The model is an all-wheel-drive RC car chassis with a built-in Brushed Electric Motor and a 2.4 GHz receiver, a programmable electronic driving
controller and a steering servo.
The RC model is pre-mounted ready for use and comes with a remote control transmitter.
The model is intended for both indoor and outdoor use.
The chassis is light and torsion-resistant. The encapsulation protects the transmission from dirt and stones.
The electronic trolley is optimally tuned to the engine and impresses with its excellent starting behavior, acceleration and constant running
characteristics. The powerful steering servo has a high positioning torque and high positioning speed with maximum stability.
A servo saver also protects the servo against violent impacts against the wheels. With the 2.4 GHz remote control system, you have a radio
remote control system that is ideally suited for model cars and model ships. Two control functions can be operated remotely via the propor-
tional function channels.
The 2.4 GHz transmitter and the receiver tuned to it do not operate on a frequency fixed by transmitter and receiver quartz. Transmitters and
receivers scan the frequency band after an available, free frequency, after which the radio connection is established.
Intended Use
The product is designed exclusively for private use in the model building sector and with the associated operating times. This product is not
approved for commercial or industrial use or for continuous operation. Improper use can lead to the risk of injury to persons as well as to
damage to the product and the associated hazards, e.g. loss of control over the model, short circuit, fire, electric shock, etc.
Observe the safety instructions in this manual. These contain important information on handling the product.
The product is suitable for children under 14 years of age only under adult supervision.
Dispose of the model, battery and charger at the end of their life according to the legal regulations.
Please avoid longer full throttle rides and allow the motor, ESC and battery to cool down during rides!
USB-Charger:
Please connect the USB charging cable to a USB port with at least 1.5 A, e.g. Computer, USB power supply, power bank, etc.
A red LED is lit in the USB connector to check the power supply. Now connect the standard rechargeable battery to the USB charging cable via
the white balancer connection. Now a second LED in the USB connector starts flashing green - this indicates the charging process.
As soon as the battery is fully charged, the green flashing LED goes out again, the red LED remains steady. The charging process is now finis-
hed, please disconnect the battery charger cable and the charging cable from the USB power source.
5. Binding procedure of transmitter and receiver
The binding between transmitter and receiver was done in factory. However if you want to re-bind please follow this instruction:
1.
Transmitter and receiver must be off.
2.
Switch on the receiver
3.
Switch on transmitter within 5 seconds.
4.
The receiver's LED will blink for 3-8 seconds.
5.
When the LED stops blinking, the binding is done successfully.
10
MODSTER ROOKIE
www.modster.at
Werbung
