Troubleshooting Guide; Care And Maintenance - Co/Tech Dust Extractor Rdc100J Bedienungsanleitung

Operating instructions
1. Place the dust extractor on a dry and level surface.
2. Make sure that the suction hose is properly attached to the collection tank and
the woodworking machine.
3. Plug in the mains lead into a power point and set the on/off switch [ I/0 ] to the l position.
4. Start the woodworking machine.
5. Turn off first the woodworking machine/power tool and then the dust extractor
once you have finished.

Troubleshooting guide

The dust extractor
fails to start.
Poor suction.

Care and maintenance

Note: Always unplug the mains lead from the wall socket before cleaning or
maintenance of any sort.
• If the product is not to be used for an extended period, it should be unplugged and
stored in a dry and dust-free location out of reach of children.
• Check the content level and empty the collection tank regularly.
• The product should be cleaned of all dust regularly. Use a fine brush or a cloth.
Use only mild cleaning agents, never solvents or corrosive chemicals.
• Is the dust extractor switched on?
• Make sure the mains lead is undamaged and securely
connected to the wall socket.
• Check that the wall socket is live.
• Make sure that the suction hose is undamaged and
is securely connected to both the dust extractor and
the woodworking machine.
• Check that neither the suction hose of the hose inlet port
or the woodworking machine is clogged.
• Does the collection tank need emptying?
6