Operation - Virutex PEB50 Gebrauchsanweisung

8. OPERATION

Observe safety regulations.
Direction of work - clockwise
Working mode
Switch on the main switch (3). The control lamp (A) lights up when
the glue has reached a temperature of 150°C. Depending on the
granular glue the machine has to warm up for 4 to 8 minutes to
get 150°C. After this time has elapsed only short workpieces can
be glued. For gluing larger or several workpieces it is imperative
to wait until the granular material has become liquid (ca. 20
3
minutes). Open lid and check.
Place the sliding plate (2, Fig. 1 y 2) onto the work piece and place
the pressure roll (15, Fig. 1 y 2) close to the workpiece without
touching it. Hold the machine with the "right hand" and switch
on "I" the Feed switch (A) on the left hand grip.
A
Lead the edge tape with your left hand through the guides (17 y
18 Fig. 2) up to the Feed roller (19, Fig. 2).
The tape is transported forward automatically now. Wait a moment
till the tape reaches the pressure roll (15, Fig. 2) and press the
pressure roll against the workpiece. The rotation movement of the
pressure roll (15, Fig. 2) automatically moves the machine ahead
with a speed of 3.6 – 4 m/min.
Pushing the machine forward will result in inconsistence speed.
At the end of the tape make sure that the machine is led further
uniformly in height and direction until the protruding tape is led
out of the pressure roll (15, Fig. 2).
REMARK:
To get used to the correct work procedure we recommend gluing
some short workpieces to find out the correct handling. You will be
surprised how easily and precisely the machine can be handled.
You should constantly monitor the glue supply and refill it at an
early stage. It will still take approximate 1 minute for additional
glue to melt after the initial heat up.
Stationary use
Your PEB50 Edgebander can be converted into a stationary unit on
a work table with the "Fix Bracket" enclosed (Fig. 5 y 6).
Work table thickness must be 19 mm (Fig. 6).
Cut a window on work table using "Fix Bracket" as template (Fig. 4).
Mount "Fix Bracket" to bottom of work table (Fig. 5) with the
Wood Screws (10 pieces enclosed).
Remove Sliding Plate (2, Fig. 1 y 2) and mount the Edgebander
to Fix Bracket (Fig. 6) with the M6 Screws enclosed.
A "Support Pad" is required. (Approximate 3 mm in thickness)
(Fig. 6).
By raising work piece 3 mm above table surface and allow "Bottom-
Trim" clearing space, (excess tape to be trimmed on bottom).
Glue Selection
Recommended Glue: Virutex especially developed granulate for PEB50,
12