Operation; Switching On The Remote Controlled Socket; Turn Off The Remote Controlled Socket; Cleaning - Silvercrest 0474759 Bedienungshinweise Und Sicherheitshinweise

Preparation / Operation / Maintenance / Troubleshooting
The remote controlled socket
only be plugged in the the direction
shown on the device label for the spray
water protection to be guarantied
(arrow must be pointing up).
The range of the remote control's
radio signal reaches max. 40 m and is
dependent on the structural conditions.
The range can be impaired by struc-
tural (e.g. steel concrete), electrical
(e.g. electric lines) or electromagnetic
(e.g. telephones) conditions. If needed,
remove the source of disturbance or
keep an appropriate distance from the
source of disturbance.

Operation

Switching on the remote
controlled socket
Plug the remote controlled socket
in an earthed shockproof socket.
Plug in the device which you want
to control remotely in the remote
control socket
Press the allocated ON button
of the remote control
switch on the remote controlled
socket
.
7
Turn off the remote
controlled socket
Press the allocated OFF button
on the remote control
to switch off the remote controlled
socket .
7
can
7
1
7
.
7
4
(e.g. A) to
1
3
(e.g. A)
1

Cleaning

ATTENTION! RISK OF
ELECTRIC SHOCK! Before
cleaning, always unplug the
remote control socket
socket and remove all plugs from the
socket.
ATTENTION! RISK OF
ELECTRIC SHOCK! Do not
allow any liquids to enter the
device.
Please use a soft cloth for cleaning
the housing. Never use petrol,
solvents or cleaning agents that
attack plastic.

Maintenance

Check the batteries for damage at
regular intervals.

Troubleshooting

= Disturbance
= Cause
= Rectification
The operating control light
on the remote control does
not goes on when pressing
a button.
The batteries are falsely inserted.
Put the batteries in the right way
round.
from the wall
7
2
GB 21