Preparation; Preparing The Remote Control; Synchronise The System Code; Inputting The System Code Into The Remote Control - Silvercrest 0474759 Bedienungshinweise Und Sicherheitshinweise

Remove spent batteries immediately
from the device.

Preparation

Before using these devices you must
insert the batteries,
synchronise the system code for the
remote control
controlled socket
switch ,
6 10
allocate a ON/OFF button pair
on the remote control
3
remote controlled socket
Preparing the remote
control
Open the battery compartment on
the back of the remote control
by pushing away the battery com-
partment cover
then up.
Insert two enclosed batteries AAA.
Press one of the ON/OFF buttons
, to test whether the remote
4 3
control works. If it does, the
1
power indicator light
on. If this light is not lit then the
device is not receiving any energy
from the batteries. Check if the
batteries are in the right way.
Close the battery compartment.
and the remote
1
using the DIP
7
and
4
to a
1
.
7
1
downwards and
5
will come
2
Safety / Preparation
Synchronise the
system code
To use this device for the first time the sys-
tem code must be synchronised by using
the DIP switch
the remote controlled sockets
to the remote control's
Each remote controlled socket
assigned to a button pair on the remote
control so that each remote controlled
1
socket can be operated separately.
7
Note: Change the position of the DIP
,
switch ,
6 10
a small screw driver with which the DIP
switch ,
6 10
downwards.
Inputting the system
code into the remote
control
Open the battery compartment on
the back of the remote control
by pushing away the battery com-
partment cover
then up.
With the DIP switch
system code with the number 1 to 5.
Close the battery compartment.
Inputting the system
code into the remote
controlled socket
Turn the screws
with a crosshead screw driver size
PH0.
, in order for all
6 10
to react
7
radio signal.
1
must be
7
with a suitable item, e.g.
can be push upwards or
downwards and
5
put in any
6
of the cover
12
GB
1
11
19