Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Deleting all codes:
To delete all codes, first repeats
steps 1 – 3.
Then with the LED operating status
display
flashing, press the
5
ALL-OFF button
control. The LED operating status
display
will flash rapidly for
5
approx. 2 seconds to confirm dele-
tion, then go out.
Setting-up operation
Q
Using the radio-controlled
Q
socket (fig. B)
1. Put the radio-controlled socket into
any shuttered socket and connect
the appliance you want to operate.
2. Switch the electrical appliance on.
The radio-controlled socket can
only perform its switching function
when the device to be controlled is
switched on.
ATTENTION! FIRE HAZARD!
Do not attach any appliances which
could cause fires or other damaged
if left unattended when switched
on. The maximum load of every
radio-controlled socket is approx.
3,680 W. Any overload could cause
a risk of fire or damage to the device.
113854_silv_Funksteckdosen-Set_Content_DE_AT.indd 17
Setting up / Setting-up operation
on the remote
3
Using the remote-
Q
control (fig. A)
The remote control will control up to 4
remote-controlled sockets (individually,
in groups or simultaneously).
1. Press the desired ON button of the
channel ON/ OFF button
C or D) on the remote control of
the device you wish to switch on.
The LED operating status display
will light.
2. Press the desired OFF button of the
channel ON / OFF button
B, C or D) on the remote control for
the device you wish to switch off.
The LED operating status display
will go out.
3. Confirm the ALL ON / OFF button
to switch all remote-controlled
3
sockets simultaneously.
Trouble-shooting
Q
If the remote control does not
work, please check the follow-
ing points:
Prob-
The operating indica-
lem
tor
on the remote
1
control device illumi-
nates but there is no
reaction
· Check that the batteries
Rem-
edy
still have enough power.
If applicable put in new
batteries.
(A, B,
2
5
(A,
2
5
GB
17
17.06.15 10:24
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
