Velleman CAMSET29 Bedienungsanleitung Seite 5

• Remove the adhesive foam.
Step 3
• Please note the UP sign at the
back of the camera.
• Turn the camera part upward.
• Gently slide the camera cable
through the hole and attach the
camera by pressing the adhesive
foam.
• Make sure the connector on the
wire is turned to the outside.
• Please note the UP sign at the
Step 4
back of the bracket.
• Slide the cable through the
bracket.
• Slide the screws from the large
part to the smaller part of the
slots.
• Tightly fix the screws and the
Step 5
bracket tightly.
• When finished, gently straighten
the camera cable.
• Open the battery lid.
Step 6
• Insert the Micro SD card as
shown.
• Install the batteries as shown.
Note: The device will only recognize
the SD card if inserted before the
batteries.
V. 01 – 05/02/2014
CAMSET29
5 ©Velleman nv