Ufesa Multitronic DE2UF18 Gebrauchs- Und Montageanleitung Seite 16

Operating instructions
Please read the operating instructions carefully before
you use the appliance!
Safety information
This appliance is intended for domestic use or for house-
hold-based non-commercial applications. Household-based
applications include, e.g. usage in employees ca ter ing fa-
cilities for shops, offices, agricultural and other commercial
operations, as well as usage by guests of guest houses,
small hotels and similar residential establishments.
Risk of electric shock!
Switch off the mains voltage supply immediately if
a fault occurs.
We do not accept liability for damage resulting from
failure to heed these instructions.
The continuous-flow heater may only be connected
and put into operation by a qualified professional.
Repairs may only be undertaken by a suitably qualified
specialist to avoid potential sources of danger.
The continuous-flow heater may only be installed in a
frost-free room.
Persons (including children) with diminished bodily, sen-
sory or mental perception, or those who lack knowledge or
experience should not operate the appliance, unless they
are monitored or have received instruction concerning use
of the appliance by persons responsible for their safety.
Keep children away from the appliance. Please moni-
tor children to ensure that they do not play with the
appliance.
The mixer and the warm water pipe may be hot .
Please switch off all fuses immediately if a malfunction
occurs. Immediately shut off the cold water supply to the
appliance should it leak. The malfunction can only be re-
paired by a specialist or an authorised service agent.
How to operate the continuous-flow
heater
The warm water temperature can be continuously adjusted
on the electronically regulated flow-through heater:
Washbasin
Shower
With the use of a thermostat battery, the following settings
are recommended for high temperatures or large quantities
of water, for example:
Dish washing
Cleaning
10
EN
Turn on the hot-water tap.
The continuous-flow heater switches on and heats the water
when the hot-water tap is turned on.
It switches off again when the tap is turned off. Changing
the supply water temperature correspondingly changes the
outgoing water temperature.
Increasing the water temperature
If a higher temperature for a completely opened warm water
tap is not achieved, more water flows than the flow-through
heater can warm as a result its performance capabilities. In
this case, the warm water tap must be closed somewhat.
Decreasing the water temperature
Startup after a water cutoff
Switch off the appliance (unscrew the fuse in the house
electrical installation).
Turn on the hot-water tap until the air is purged from the
pipe.
Switch the fuse back on again.
The appliance is ready for operation.
Saving energy
Set the desired warm water temperature directly on the
flow-through heater.
Mixing with cold water at the armature for water that is too
hot consumes unnecessarily water and energy.
At approx. 40 ° C (temperature selection position
unit operates most economically.
Cleaning
Simply wipe the appliance with a damp cloth.
Do not use intensive or abrasive cleaning agents.
) the