Quax CAMILLE Handbuch Seite 24

CAMILLE
Quax Quax
First dreams
® ®
First steps
Step 4 : Use the parts of steps 2 and 3, the transversal crossbeam P, seven wooden dowels a, one cylindrical
nut and bolt m, four eccentrics c, the right side D, the support top E and 3 wood screws e
Insert four wooden dowels (a) and four eccentrics (c) in the provided openings of the upper and lower crossbar.
Push the intermediate side (C) with its connectors in the drillings of all crossbars and tighten the eccentrics. Insert
a wooden dowel (a) and a cylindrical nut (m) in the provided opening of the transversal crossbeam (P). Push the
crossbar with its dowel in the opening on the right side (D). Push the bolt (m) in the drilling on the side and tighten.
Push two wooden dowels (a) in the openings on the right side (D). Push the support top (E) over the dowels,
insert three wood screws (e) in the drillings of the top and fi x them in the side.
24
Bureel met drie laden
76 10 06 0xx
Schreibtisch mit drei Schubladen
Step 5 : Use the parts of step 4, three wooden dowels a, one cy-
lindrical nut and bolt m and 3 wood screws e
Insert the wooden dowels (a) in the provided openings at the top
and bottom of the intermediate side (C). Insert a cylindrical nut (m)
in the drilling of the transversal crossbar (P). Push the legframe
over the dowels. Push the bolt (m) in the drilling on the side and
tighten. Insert three wood screws (e) in the provided openings of
the support top (E) and fi x them in the intermediate side.
Bureau avec trois tiroirs
Desk with three drawers
Step 6 : Use the parts of step 5, the top A,
four wooden dowels a and ten wood screws
d
Insert the wooden dowels (a) in the provided
openings at the bottom of the top (A). Push
the top with its dowels in the drillings of the
undercarriage. Insert one by one a wood
screw into the holes at the back of the under-
carriage and tighten them into the top.