Yedoo MEZEQ Einleitung Seite 10

EN
ASSEMBLY INSTRUCTIONS
Assembly of the front (bigger) Make sure the front fork of the
wheel: open the quick-release
scooter is well positioned (brake
lever and loosen the nut. levers are facing forward). Release
the brake cable from its holder
and loosen the brake arms.
Assembly of the rear wheel is The upper dropout, which also
the same as the assembly of the makes the footboard go lower
front wheel with the only excep- and thus reduces the load on the
tion of double dropout at the standing leg, is intended for flat
rear fork. It allows positioning the surface. Riding will be less tiring.
footboard according to the road
conditions. The lower dropout
enables off road riding.
18
Place the wheel into the front fork Tighten the nut
feel resistance before closing the
so that is well-centred.
quick release. Close it in a way
The tread pattern (arrow-shaped lines
that the quick release lever
on the tires) must be pointing to the front.
points backwards (for safety
reasons). Return the brake cable
into the holder.
Installation of brake cables: Adjustment of brake levers:
press the brake lever to the maxi- incline the brake levers correctly
mum and insert the ending of the by loosening the screw on the
brake cable into the circular fixing sleeve.
point. Repeat the action with
The right inclination: stand on the
both brakes.
footboard, hold the handles and stretch
out your fingers in a way that your arm and
The rear brake cable is usually fixed on
the fingers form a single straight line. This
the right, front brake cable on the left.
should be the position of the brake levers.
Handlebar installation: place
(1) until you can
the handlebar tube as shown
on the picture and tighten the
(2) screws on the stem.
Adjustment of brakes: when
braking, check that the brake
pads of both wheels fit tightly on
the rim sides. If not, you can ad-
just their position via a screw that
connects them to the V-brake
arms (1). The pads shall not touch
the tires.
Insert the handlebar tube into the
front frame (1) and adjust the height
according to the rider's needs
(not higher than indicated by the
line). Check that the handlebar is
upright and properly tighten the
screw on the handlebar tube (2).
Check that the pads make enough
space (1–2 mm) after releasing
the brake levers. The distance
can be adjusted by tightening or
loosening the brake cable at the
anchor screw (2).
In case the brake pad is touching
the wheel when turning, symmet-
rically adjust the distance of brake
arms by the tightening screws (3).
19 19