Alarm Manager - Abus IPCB24500 Bedienungsanleitung

Delete:
Threshold value:
Day sensitivity:
Night sensitivity:

10.4.7 Alarm manager

Alarm manager:
Trigger:
Schedule:
Action:
Add:
Edit:
Delete:
The following triggers for events are available:
Switching input:
Motion detection:
Restart:
Watchdog error:
Day/night switching:
Authentication error:
Continuous trigger:
mask further on in the preview. Selecting a second one will remove
the previously selected mask. The masks are applied by saving
them to the settings.
selecting a range in the list and pressing this button deletes the
range.
represents the area that has to be changed in the video frame
represents the rate of change (day mode)
represents the rate of change (night mode)
in alarm manager you can create rules for handling events.
A maximum of one trigger can be used for each rule.
A maximum of one action can be set for each rule.
A maximum of five rules can be created for handling one event.
select the event trigger
defines when the rule should be active (in half hour increments). If
an area is marked as red, it's marked as active.
you can choose between two events:
1) Email
An email can be sent to a specific recipient. The content and subject
line can be assigned. It is also possible to select a certain number of
pre- and post-alarm images.
2) FTP
It is possible to select a certain number of pre- and post-alarm
images.
adds a new event rule
edits an event rule
deletes an event rule
All cameras in this series have a switching input (an optional cable
in dome cameras). On standby, you can select N.O. (normally open)
or N.C. (normally closed).
select the camera's internal motion detection. This will analyse all
configured masks. It is not possible to detect which mask has made
the trigger.
triggering when the camera restarts
the system can restart automatically after a serious malfunction (this
is known as 'watchdog'). This can be used as a trigger.
choose between switching to day or night mode as an event trigger.
entering an incorrect password twice can be used as a trigger.
The Continuous trigger is used to send a single image to an FTP
server at a certain interval (30 sec - 24h). The existing file is always
overwritten (rights on the FTP server for overwriting must be
present).
90