Denon DN-508MXA Benutzerhandbuch Seite 6

Setup
Items not listed under
To set up DN-508MXA with your sound system:
1. If you are using any audio source with RCA outputs (Blu-ray
cables to connect them to the ST inputs on the rear panel. Your audio sources must be line-level (no
phono-level turntables).
2. If you are using an amplifier or other audio source with outputs that can be wired into standard
Euroblock connectors, connect them to the Mic/Line Inputs on the rear panel.
3. Use the included 5-pin Euroblock with jumper wires to connect Line Outputs 1–4 to Amp Inputs 1–4.
Each group of 5 connections corresponds to 2 zones. Each zone has a hot (H) and cold (C) connector,
and each pair of zones shares the ground (G) connector.
4. Use standard Euroblock connectors to connect the loudspeakers of your different zones to the
Speaker Outputs on the rear panel. For LoZ speakers at 4 Ohm or 8 Ohm, each group of 2
connections corresponds to 1 zone, for 4 total output zones. For HiZ speakers at 70 V, 100 V, or BTL,
each pair of groups of 2 connections corresponds to 1 zone, for 2 total zones. Each zone has a positive
(+) and negative (-) connector. Always make sure to properly align the wiring polarities between your
speakers and DN-508MXA.
5. To manage DN-508MXA using its web interface, connect the Ethernet Port and your computer to a
network switch or router using standard Ethernet cables. If your computer is wirelessly connected to
your router, connect just DN-508MXA to that router. Alternatively, connect DN-508MXA's Ethernet Port
directly to a computer using an Ethernet crossover cable.
6. To manage DN-508MXA using serial communication, connect the remote port to your computer
using a 9-pin D-Sub cable. Use a third-party utility to manage DN-508MXA. Alternatively, connect the
RS-422 port to a third-party utility using a standard analog telephone cable with RJ45 connectors.
Tip: We recommend using the web interface to control DN-508MXA rather than serial communication. It
is much easier to use the web interface via IP communication than a third-party utility via RS-232 serial
communication.
7. Use the included power cable to connect DN-508MXA to a power outlet.
8. Power on all of your audio sources (Blu-ray
9. Power on DN-508MXA.
Example:
To Zone Speakers
Computer
Router
Zone 1
6
Introduction > Box Contents
Jumper Wires
(Connects Line
Outputs 1–4 to
Amp Inputs 1–4)
Blu-ray Player
Zone 2
are sold separately.
®
players, stereos, etc.), use standard RCA
®
players, stereos, microphones, amplifiers, etc.).
Zone 3
Amplifier
Microphones
Zone 4
Power