Rear Panel - Denon DN-508MXA Benutzerhandbuch

Rear Panel

12
9
8
11
1. Power Input: Use the included power cable to connect this input to a power outlet.
2. Line Outputs: Use Euroblock connectors to connect these line-level outputs to your
loudspeakers or other audio devices. Each group of 5 connections corresponds to 2 zones.
Each zone has a hot (H) and cold (C) connector, and each pair of zones shares the ground (G)
connector. Make sure each loudspeaker is connected to the desired zone.
To send audio signal to the Speaker Outputs, use the included
to connect the Line Outputs of Zones 1-4 to the Amp Inputs of Zones 1-4.
3. Mic/Line Inputs: Use Euroblock connectors to connect your mic-level or line-level audio
sources to these inputs. Each input has a hot (H), cold (C), and ground (G) connector. Inputs 1
and 2 have an additional connector for Page Switch. Remember to adjust the Gain knob to set
the input volume level.
4. Mic/Line Gain: Turn these knobs to set the input gain for each Mic/Line Input.
5. Aux In (RCA): Use a standard stereo RCA cable to connect an optional audio source to this
stereo input. When a cable is connected to the Aux In on the front panel, these inputs will be
disabled.
6. ST Inputs: Use standard stereo RCA cables to connect line-level audio sources to these inputs.
7. Mute Connector: Use a 2-pin Euroblock connector to attach a switch to this connector. The
switch can then mute or unmute the incoming signal from all audio sources.
8. Remote Port: This port lets you connect a computer to DN-508MXA. Use a 9-pin D-Sub cable
to make this connection. You can use the computer with a third-party utility to manage DN-
508MXA via serial communication.
9. Remote Extend Port: This port lets you connect another DN-508MXA to the host device. Use a
9-pin D-Sub cable to make this connection. You can use a computer with a third-party utility to
control all connected DN-508MXA units via serial communication.
10. RS-422 Port: This port lets you connect a host device to DN-508MXA. You can then use a third-
party utility to control DN-508MXA via serial communication. Use a standard analog telephone
cable with RJ45 connectors to make this connection.
11. Ethernet Port: This port lets you connect DN-508MXA to a network. Connect this port to a
computer via a network switch or router. Alternatively, connect it directly to a computer using an
Ethernet crossover cable. This connection lets you control DN-508MXA though the web
interface.
12. Speaker Output: Use Euroblock connectors to connect these outputs to your loudspeakers at
low-impedence (LoZ), high-impedence (HiZ) or BTL (bridge-tied load). When using LoZ, each
group of 2 connections corresponds to 1 zone, for 4 total zones. When using HiZ and BTL, each
pair of groups of 2 connections corresponds to 1 zone, for 2 total zones. Each zone has a
positive (+) and negative (-) connector. Make sure each loudspeaker is connected to the desired
zone and that the wiring polarity is correct.
13. Amplifier Input: Use Euroblock connectors to connect line-level audio sources to these inputs.
Each zone has a hot (H) and cold (C) connector, and each pair of zones shares the ground (G)
connector.
To send audio signal to the Speaker Outputs, use the included 5-pin Euroblock with jumper
wires to connect the Line Outputs of Zones 1-4 to the Amp Inputs of Zone 1-4.
14. Fan: The speed of the fan adjusts automatically to cool the unit.
14
13
7
10
2 5 6
4
1
3
5-pin Euroblock with jumper wires
5