Denon DN-508MXA Benutzerhandbuch Seite 13

I/O Name
This window shows the names of all of your
inputs (Mic/Line Inputs, ST Inputs, and Aux
In) and zone (Line Outputs). Click each field
and enter a name using your computer
keyboard. Click Save to save the names.
System
•
Setting File: This field shows the
currently loaded setting file, if any. To
download the current setting file (if any)
to your computer, click Download. To
upload a setting file from your computer
to DN-508MXA, click Browse, find and
select the file, and then click Upload.
•
Mic/Line: For each mic/line input,
select whether
microphone (Mic) or a line-level device
(Line), whether the high-pass filter
should be enabled (On) or disabled
(Off), and whether the microphone
should receive phantom power (On) or
not (Off). Please
dynamic microphones do not require
phantom power, while most condenser
microphones
microphone's documentation to find
out whether it needs phantom power.
•
Source: Click each Gain menu to set
the gain trim level of each audio source.
All sources have an editable automatic
gain control (AGC), which adjusts the
gain level to help reduce noise in the
signal:
Compensation Level: Click this
o
menu to set how much gain is
applied after
compressed by the AGC.
Response Time: Click this menu to
o
set how quickly the AGC reacts to
audio signal.
Noise Gate: Click one of the
o
buttons to enable (On) or disable
(Off) the noise gate. When on, the
audio signal will be automatically
muted if it is below a certain volume
level. This
during which the source is not
producing any sound but there is
still detectable noise in the audio
signal.
the input is
note that most
do. Consult your
the signal
eliminates moments
a
is
13