Front Panel - Denon DN-508MXA Benutzerhandbuch

Features

Front Panel

6
1
1. Power Button: Press this button to power DN-508MXA on or off.
2. Display: This screen indicates the current settings, status, etc.
3. Volume/Sel: Turn the knob to navigate or scroll through the options shown in the display, and then
press the knob to select one.
4. Menu: Press this button to switch between the Menu and the settings of the current zone in the display.
In the Menu, turn the Volume/Sel knob to navigate or scroll through the available options, and then
press the knob to select it.
5. Mute/Back: When viewing the settings of the current zone, press this button to select the Mute setting.
To mute or unmute the zone, turn the Volume/Sel knob to select Mute or Unmute, and then press it to
confirm your choice.
When in the Menu, press this button to return to the previous screen.
6. Aux In (1/8" / 3.5 mm): Use a standard stereo 1/8" (3.5 mm) cable to connect an optional audio source
to this stereo input. When a cable is connected to this input, the Aux In (RCA) inputs on the rear panel
will be disabled.
7. Mic/Line Indicators: These lights will illuminate different colors to show the signal status of each
mic/line input:
•
Off: The input is receiving no signal or a very low-level signal.
•
Green: The input is receiving a signal at an optimal level.
•
Amber: The input's signal is very high.
•
Red: The input's signal is "peaking" (higher than 0 dB). Decrease its Gain knob on the rear panel
or decrease the volume of the source to prevent "clipping" (distortion).
8. Source Indicators: These lights will illuminate different colors to show the signal status of the aux in
and ST inputs:
•
Off: The input is receiving no signal or a very low-level signal.
•
Green: The input is receiving a signal at an optimal level.
•
Amber: The input's signal is very high.
•
Red: The input's signal is "peaking" (higher than 0 dB). Decrease the volume of the source to
prevent "clipping" (distortion).
9. Source Selectors: Press one of these buttons to assign or unassign that source to the currently
selected zone. When a source is assigned to the zone, its button will be lit amber. To select a zone,
press one of the Output Selectors.
10. Output Indicators: These lights will illuminate different colors to show the signal status of the line
outputs (zone outputs):
•
Off: The output is sending no signal or a very low-level signal.
•
Green: The output is sending a signal at an optimal level.
•
Amber: The output's signal is very high.
•
Red: The output's signal is "peaking" (higher than 0 dB). Decrease the volume of the zone to
prevent "clipping" (distortion).
11. Output Selectors: Press one of these buttons to select that zone. The button for the currently selected
zone will be lit amber.
12. Protection Indicator: These red LEDs will light when amplifier protection is engaged for the Speaker
Outputs. The LEDs correspond to Zones 1-4.
4
4
3
2
5
12
PROTECTION
9
DN-508 MXA
DVD
CD
Phone
7 8
11
Dining Dance
Kitchen
Room L Hall L
Dining Dance
Room R Hall R
10