Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E
N
Undertake only the maintenance operations described in the user instructions.
Contact the Technical Assistance service for all other interventions.
Use only original spares.
Should the power cable be damaged, it must be replaced by a cable or a set of special cables available from
the manufacturer or its assistance service.
The pins and joints of the connection cables of the electrical system must be protected against accidental water
sprays.
STORAGE
Store the appliance in premises protected against freezing conditions.
If freeze protection is not guaranteed, suction a glycol based anti-freeze into the pump, as for cars
- Immerse the water pipe into the container of anti-freeze
- Immerse the gun without the sprayer nozzle into the same container
- Insert the appliance with open gun
- Activate the gun until an even jet is obtained.
Store the rest of the anti-freeze in a closed container.
Treatment of waste from electric/electronic equipment
Dispose of the product in accordance with current regulations concerning differentiated waste disposal
in dedicated waste disposal areas. Do not treat as simple urban waste.
For any information please contact the manufacturer at the address specified in the user manual.
The product complies with the requirements of the new directives introduced for the environmental safeguard
and must be disposed of appropriately at the end of its life cycle.
10
TROUBLESHOOTING
Before starting any work the machine, unplug the power cable, turn off the water supply and actuate the spray
gun until the pressure has been relieved completely.
Fault
Pressure fl uctuates or drops
Motor hums when switched on,
but does not start
Motor will not start when switched
on
Motor stops
The detergent fails to come out Clogged injector
Jet is ineffective, ragged unstea-
dy
Cause
Lack of water
Water fi lter clogged
Mains voltage too low
Spray gun not actuted
Cross-section of extension lead
too small
Power supply not OK
Mains fuse tripped
Motor protection switch tripped
due to motor overheating
Clean the nozzle of the foam
launch
Selector sleeve for type of jet
wrongly set
Remedy
Turn on water supply
Clean the water fi lter on the
pump supply tube.
Check electrical connection
On switching on the machine,
engage the gun
Use correctly dimensioned exten-
sion lead, see "Connect machine
to power supply"
Check plug, cable and switch
Resert mains fuse
Check that power supply matches
appliance voltage, wait 3 minutes,
then switch machine on again
Clean the detergent spray nozzle
element
Clean the high pressure nozzle.
Adjust selector sleeve
Werbung
Inhaltsverzeichnis
