Ego Power+ LM2120E Bedienungsanleitung Seite 13

To Stop (Fig. Q)
1) Fully release the bail switch.
2) The electric brake in the Automatic Braking
Mechanism will stop the blade rotation within 3
seconds of the bail switch release.
VARIABLE-SPEED SELF-PROPEL SYSTEM
LM2120E-SP mower is equipped with variable-speed
self-propel capability. This system is independent of the
blade On-Off switch; it is not dependent on blade rotation.
To operate the system without blade rotation, pull the
self-propel trigger to the handle.
To turn the self propel off, release the self-propel trigger.
The system has variable speed. To increase the speed,
move the self-propel speed-control lever forwards. To
decrease the speed, move the self-propel speed-control
lever backwards (Fig. R).
To operate with the blade rotating for cutting:
1. Start the mower.
2. While holding the bail switch against the handle
with your left hand, pull the self-propel trigger to the
handle with your right hand.
3. Hold both the bail switch and the self-propel trigger
simultaneously against the handle with your right
hand and use your left hand to adjust the self-propel
speed-control lever to choose the desired speed.
NOTICE:
During cutting, it may be easier to mow around
an object, such as a tree or plants, with the self propel off.
WARNING:
To reduce the risk of injury, never
attempt to override the operation of the switch or self
propel system. Use the self propel for its intended purpose
only.
LED HEADLIGHTS (Fig. A-7)
Press the switch button (Fig. C-22) to turn on/off the LED
headlights in the front of the battery compartment.
POWER INDICATOR ON THE MOWER (Fig. S)
The mower is equipped with a power indicator to indicate
the charge status of the battery pack and the working
status of the mower. The power indicator will illuminate
when the blade is rotating or when the LED headlights are
turned on.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2120E / LM2120E-SP
Power
Indicator on Meaning
Mower
Mower is working
properly; battery
Shining green
has at least 15% of
its charge
Shining red Low battery
The battery is
Flashing red
nearly depleted
The mower or the
Shining
battery pack is
orange
overheated
Flashing The mower is
orange overloaded
MOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too
much grass at one time. Slow down your cutting pace or
raise the cut height.
Your mower has built-in overload circuit protection. When
the mower is overloaded, the motor will stop and the
power indicator on the mower will flash orange. Remove
the battery pack from the mower. Check to see if grass
has collected beneath the deck and clear it if necessary,
then install the battery and restart the mower.
BATTERY HIGH TEMPERATURE PROTECTION
The battery pack will generate heat during operation. The
heat dissipates more slowly in hot weather. If the battery
temperature exceeds 70°C during operation, the protection
circuit will immediately turn off the mower to protect the
battery pack from damage. The power indicator on the
mower will shine orange and the LED on the battery will
flash orange. Release the bail handle, wait until the battery
pack cools down to approximately 67°C , then restart the
mower.
MAINTENANCE
WARNING:
To avoid serious personal injury, always
remove the safety key from the mower before cleaning,
performing any maintenance or transporting the mower.
EN
Action
N/A
Stop the mower and
charge the battery
pack
Stop the mower and
charge the battery
pack
Remove the battery
from the mower,
move them to the
shade and cool
them at least 15
minutes
Slow down your
pace or raise up
the cut height to
decrease the load
13