AEG DIK6980SG Gebrauchsanleitung Seite 6

6 www.aeg.com
5. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control
and a light switch to control cooking area
lights. Use the high suction speed in cases
of concentrated kitchen vapours. It is
T6 T1
1 Speed ON/OFF button
Control panel on/off key
2 Suction speed (power) key 1
3 Suction speed (power) key 2
4 Suction speed (power) key 3
5 Suction speed (power) key 4
Note: suction speed (power) key 4 has
a limited duration of 10 minutes, after
which the previous suction speed is
reactivated.
6 Suction speed (power) key 5
Note: suction speed (power) key 5 has
a limited duration of 5 minutes, after
which the previous suction speed is
reactivated.
7 "Breeze" function key
(Room ventilation)
The hood switches on at low suction
speed (power) for 60 minutes, after
which it switches off.
8 Filter saturation control and
activation/deactivation key
9 Indication of active Hob
function
10 Select fi ltering mode
11 Select suction mode
12 Lights ON/OFF key
Note: hold key down to adjust the
intensity of the light
T6 T6 T6 T6
T2 T3 T4 T5
H
2
recommended that the cooker hood suction
is switched on for 5 minutes
prior to cooking and to leave in operation
during cooking and for another 15
minutes approximately after terminating
cooking.
T6 T6
T6 T7
Control panel on/off function
With the hood in standby, press key1, all
led lights will switch off: the control panel
is off.
Press key
the control panel is active.
Carbon fi lter saturation control activation/
deactivation function
With the hood in standby, press key
longer than 3 seconds
Key
saturation fi lter has been activated.
Key
the carbon saturation fi lter has been
deactivated.
Filter saturation control and reset
function
At regular intervals and depending on
the hood temperature, key
up to indicate that the fi lters need to
be maintained in accordance with the
instructions in the relative paragraphs.
Key
required on the grease fi lters
Key
required on the carbon fi lter.
ood
Filter saturation indicator reset
With the hood in standby, press key
longer than 3 seconds.
Repeat the operation if necessary.
T6 T6 T6 T10 T6
T8 T9
1 again, all led lights will turn on:
8 will fl ash to indicate that the carbon
8 will remain lit to indicate that
8 on with a fi xed light: maintenance is
8 on and fl ashing: maintenance is
T6
T11 T12
5 for
8 lights
8 for