Spare Parts And Accessories - Peltor Lite-Com Pro MT7H7F470-50 Gebrauchsanweisung

time must be decreased according to diagram D:1 (x=22 mV). An electrical input signal of 22 mV
corresponds to 82 dB (A) equivalent sound level (average value plus one standard deviation of the
measured sound level. See table D:2). Note: The maximum output effect of the earphones must not be
exceeded.
ATTENUATION VALUES (Fig. E)
1. Frequency 2. Average value 3. Standard deviation 4. Average protection value
APPROVALS
CE
The Peltor Lite-Com Pro is tested and approved as a hearing protector according to PPE directive
89/686/EEC and applicable parts of the European EN 352-1:2002, EN 352-3:2002, EN 352-4:2001 and
EN 352-6:2002 standards. Certified by FIOH, Topeliuksenkatu 41, FI-00250 Helsinki, Finland ID#0403.
Measurements for products with a helmet attachment were performed on Peltor's G22C hardhat.
The Lite-Com Pro is also tested and approved according to the following standards:
Radio: ETSI EN 300,296-2, ETSI EN 300,296-1
EMC: ETSI EN 301,489-5, ETSI EN 301,489-1
The electrical measurements were performed by SP, the Swedish National Testing and Research
Institute, Box 857, S-501 15 Borås, Sweden, ID# 0402.
ATEX
II 1 G
The Peltor Lite-Com Pro is tested and approved for use in environments with risk of explosion, in
accordance with the ATEX directive 94/9/EG EEC.
Certified by NEMKO AS, P.O. Box 73, Blindern, N-0314 OSLO, Norway.

SPARE PARTS AND ACCESSORIES

NOTE:
When using and repairing ATEX-approved equipment, all instructions and regulations must be
followed to the letter!
For more information, see:
The European Commission's website for the ATEX directive, 94/9/EG:
http://europa.eu.int/comm/enterprise/atex/
The European Commission's website for the 1999/92/EG directive:
http://europa.eu.int/comm/employment_social/health_safety
HY79 Hygiene kit
Easy to replace hygiene kit consisting of two attenuation cushions, two foam rings and snap-in ear
cushions. Replace at least twice a year to ensure constant attenuation, hygiene and comfort.
HY100A Clean – single-use protectors
A single-use protector that is easy to apply to the ear cushions. Packages of 100 pairs.
HYM1000 Mike Protector
Moisture and wind-tight and hygienic; protects the speech microphone and enhances its life span.
Packages of 5 metres, about 50 replacements.
M995 Wind protection for MT53-type speech microphones
Effective protection from wind noise; enhances the life span and protects the speech microphone.
One per package.
M40/1 Wind protection for MT7-type speech microphones
Effective protection from wind noise; enhances the life span and protects the speech microphone.
One per package.

EEx ia IIC T4
(RMS)