Safety Notes - Monacor SPEECH -200 Bedienungsanleitung

Lectern with Amplifier System
These instructions are intended for users
without any special technical knowledge .
Please read the instructions carefully prior to
operation and keep them for later reference .
All operating elements and connections de-
scribed can be found on page 2 .
1 Overview
1 Input MIC 1 (XLR jack) with a 24 V phan-
tom power for connecting a microphone
to input channel 1 [as an alternative to the
jack (7) on the rear side]
2 Reading light
3 Switch for the reading light (2 brightness
levels)
4 Input MIC 2 (XLR jack) with a 24 V phan-
tom power for connecting a microphone
to input channel 2 [as an alternative to the
jack on the rear side]
5 VOLUME control, for each input channel
1– 4
6 LED RF; will light up when a radio signal is
received at input channel 1
The signal from a wireless microphone
will be mixed to the signal at the input
of channel 1 .
The LED RF at input channel 2 has no
function .
7 Combined XLR / 6 .3 mm jack for connect-
ing a microphone via an XLR plug or a
signal source with line level via a two-pole
6 .3 mm plug for each input channel 1 – 3
The XLR contacts of the input channels 1
and 2 are supplied with a 24 V phantom
power, e . g . for electret microphones .
8 Equalizer controls HIGH, MID an LOW for
each channel 1– 3
9 RCA inputs AUDIO IN for connecting
a signal source with line level to input
channel 4; when both jacks are connected
(e . g . stereo signal from a CD player), the
signals will create the sum (mono)
10 Output LINE OUT, REC (RCA jacks) to route
the mixed signal, e . g . to a recorder or an-
other amplifier system
11 LED LIMITER; will light up when the input
level is too high and is reduced by the
limiter
12 POWER LED
13 POWER switch
14 Mains jack for connection to a socket
(230 V/ 50 Hz) via the mains cable provided
15 Support for the mains fuse
Always replace a blown fuse by one of
the same type!
16 Castors
17 Compartment; e . g . for pens or an audio
recorder or audio player
18 Shelves; e . g . for scipts / notes and this in-
struction manual
19 Storage compartment; e . g . for connection
cables
6

2 Safety Notes

The unit corresponds to a ll relevant directives
of the EU and is therefore marked with
WARNING The unit uses dangerous
mains voltage . Leave ser-
vicing to skilled personnel .
Inexpert handling may result
in electric shock .
•
The unit is suitable for indoor use only . Pro-
tect it against dripping water, splash water
and high air humidity . The admissible ambi-
ent temperature range is 0 – 40 °C .
•
Do not operate the unit and immediately
disconnect the mains plug from the socket
1 . if the unit or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the unit must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect
the mains plug from the socket, always
seize the plug .
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally
intended, if it is not correctly connected
or operated, or if it is not repaired in an
expert way .
If the unit is to be put out of oper-
ation definitively, take it to a local
recycling plant for a disposal which
is not harmful to the environment .
3 Applications
The lectern SPEECH-200 consists of a
. high-quality 2-way speaker system, a mix-
ing amplifier with four input channels and
a receiving part for a wireless microphone
with a carrier frequency of 863 .05 MHz . It
is ideally suited to reproduce sound, e . g . for
lectures, speeches, readings, etc . The optional
wireless microphone offers additional mobility
(e . g . for passing round the microphone in the
audience when questions arise) .
Besides three microphones, it will also be
possible to connect other audio units (e . g . CD
player for adding music) . Via the jacks LINE
OUT, REC, the output signal will be routed to
a recorder or to another amplifier system . The
integrated reading light offers two brightness
levels .
The two integrated castors on the rear
side of the lectern allow convenient transport .
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL de-
clare that the wireless receiver of the lectern
SPEECH-200 complies with the directive
2014 / 53 / EU . The EU declaration of conform-
ity is available on the Internet:
www .monacor .com
The wireless system (transmitter and receiver)
is generally approved for operation in EU and
EFTA countries, it is licence-free and requires
no registration .
4 Transport and Setting up
For transporting the lectern, seize the top
part and tilt it slightly backwards so that it
will stand on its two castors only . Thus, it
will be easy to wheel it to the place of appli-
cation . Set up the lectern is such a way that
the speakers on its front side will be directed
towards the audience .
5 Connections
Prior to connecting any units or to changing
any existing connections, switch off the am-
plifier system and all units to be connected .
5.1 Microphones and audio unit
1) Connect a microphone (e . g . a suitable
gooseneck microphone from the EMG...P
series) to one of the XLR jacks (1 or 4) on
the upper side of the lectern and adjust it
to the person speaking . It will also be pos-
sible to equip both jacks with one micro-
phone each . The jacks have a latching; to
disconnect the plug, press the PUSH lever .
As an alternative, connect a micro-
phone with an XLR plug to the input jack
(7) of the channels 1 and 2 on the rear side
of the lectern . Like the jacks on the upper
side of the lectern, these microphone in-
puts will supply the phantom power (24 V)
required by some microphones .
The input jack of channel 3 allows con-
nection of another microphone with XLR
plug .
2) To connect a signal source with line level
(e . g . mixer, CD player), use the 6 .3 mm