Power Management Function; Flexible Induction Cooking Area - AEG HKP87420FB Benutzerinformation

12 www.aeg.com
4.12 Power management
function
• Cooking zones are grouped
according to the location and number
of the phases in the hob. See the
illustration.
• Each phase has a maximum electricity
loading of 3700 W.
• The function divides the power
between cooking zones connected to
the same phase.
• The function activates when the total
electricity loading of the cooking
zones connected to a single phase
exceeds 3700 W.
• The function decreases the power to
the other cooking zones connected to
the same phase.

5. FLEXIBLE INDUCTION COOKING AREA

WARNING!
Refer to Safety chapters.
5.1 FlexiBridge function
The flexible induction cooking area
consists of four sections. The sections
can be combined into two cooking zones
with different size, or into one large
cooking area. The sides of the zones
which operate together light up, and
they are linked with shorter illuminated
lines. You choose the combination of the
sections by choosing the mode
applicable to the size of the cookware
you want to use. There are three modes:
Standard (activated automatically when
you activate the hob), Big Bridge and
Max Bridge.
To set the heat setting use
two left side control bars.
Switching between the modes
To switch between the modes use sensor
field: .
• The heat setting display of the
reduced zones changes between two
levels.
When you switch between
the modes the heat setting
is set back to 0.
Diameter and position of the
cookware
Choose the mode applicable to the size
and the shape of the cookware. The
cookware should cover the selected area
as much as possible. Place the cookware
centrally on the selected area!
Place the cookware with the bottom
diameter smaller than 160 mm centrally
on a single section.