AEG HKP87420FB Benutzerinformation Seite 19

Problem
There is no signal when you
touch the panel sensor
fields.
The flexible induction cook-
ing area does not heat up
the cookware.
comes on.
comes on.
comes on.
Possible cause
The signals are deactivated.
The cookware is in the
wrong position on the flexi-
ble induction cooking area.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The cookware does not cov-
er the cross / square.
FlexiBridge function oper-
ates. One or more sections
of the function mode which
operates are not covered by
the cookware.
ENGLISH
Remedy
Activate the signals.
Refer to "Daily use" chapter.
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cook-
ware depends on the activa-
ted function or function
mode.
Refer to "Flexible induction
cooking area" chapter.
Use cookware with diameter
applicable to the activated
function or function mode.
Use cookware with diameter
smaller than 160 mm on a
single section of the flexible
induction cooking area.
Refer to "Flexible induction
cooking area" chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
Cover the cross / square
fully.
Place the cookware on the
correct number of sections
of the function mode which
operates or change the func-
tion mode.
Refer to "Flexible induction
cooking area" chapter.
19