H-tronic AL600 Anleitung Seite 8

full) normally the yellow light charging) dimi-
nishes. With old batteries sometimes there
might be a small, current flowing (leakage
current of the battery). Here the yellow light
might be on, this is due to the strength of the
current. With new batteries the light will dimi-
nish once the battery is full. The charger can
charge different batteries with different capa-
cities, the bigger the battery is, the longer the
charging time will be. With smaller batteries
the charging time will be shorter.
For the charging itself it is not important if the
battery is partly or completely discharged.
The battery can stay connected to the char-
ger for a long period, the surrounding tempe-
rature should be in the
In case the baftery has been connected to
with the wrong polarity then this will be in-
dicated through a red light (verpolt) and the
charging current will be cut off.
Usage of the product
1. Choose the proper charging voltage (2, 6,
12V). Attention: the wrong charging voltage
can destroy this product
2. Connection to 230V AC
Firstly connect the charger to the 230V plug
3. Connection to the battery
Connect the red pin of the charger to the
plus part of the battery and the black part to
the minus (-) of the battery.
Notice
The product is short-term short circuit pre-
vented! Longer lasting short ‚circuits (longer
than 1 min.) must prevented under all cir-
cumstances, otherwise parts of the charger
or the electronic might be overloaded.
Attention!
• While charging the battery please pay at-
tention to the right polarity!
of 20 °C to 25 °C
• To prevent defects to the battery make sure
to never deeply discharge the battery during
the charging!
• Make sure to have enough air supply!
• Open the cells of the lead acid battery be-
fore charging! • Check the acid of the battery
for longer charging!
• Check the acid of the battery in between
always make sure not to have any open fire,
open light and glimmers close to the charged
batteries (danger of explosion due to gas)!
• Always check the charging instructions on
the battery (normally printed on the battery).
Technical data
Charging Voltage:
max. current:
Operating Voltage:
(LED green)
Malunctions
If it can be assumed that the charger cannot
be operated anymore without any danger,
the charger has to be taken out of operation
and it has to be made sure that it cannot be
operated unintentionally,
This applies when:
• the product shows obvious defects
• the product doesn't function any more
• parts of the product are loose l connecting
cables show defects
In case of repairing the product use only ori-
ginal spare parts. The usage of other substi-
tutes can lead to serious defects.
Repair of the product has to be carried out
by experts.
Warranty
We grant warranty of 2 year for this product:
The warranty includes free of charge repair
of defects, which result clearly from incorrect
materials or manufacturing mistakes.
8
2,3/6,9/13,8 Volt
0,6 Ampere
230V /50 Hz AC