TESY CN03 050 EIS Bedienungsanleitung Seite 3

•
The power socket should be accessible all the time
in order to disconnect the power plug when needed
as fast as possible! Never pull the power cord or the
appliance itself in order to disconnect it from the
mains.
•
PAY ATTENTION! Outgoing air gets heated during
appliance operation (up to more than 100
•
If the power cord of the appliance gets damaged,
stop the heater and call its supplier/retailer for
further instructions.
•
If you decide to stop using an appliance of this kind,
it is recommended to make it unusable by cutting
its power cord after you have disconnected it from
the mains. It is advisable all possible risks related to
the appliance to be secured, especially in relation to
children that may play with out-of-use appliances.
•
The appliance must not be placed right under a
socket box!
•
Warning: Do not use this appliance with a
programmer, counter or any other mechanism
which could automatically turn on the heater – if
the appliance is covered or positioned incorrectly
there is a risk of fire.
•
Position the power cord in such a way that it does
not obstruct the free movement of people and
cannot be stepped on! Use only approved extension
cords, which are suitable for this appliance, i.e. they
have a compliance sign!
•
Never move the appliance by pulling its power
cord; do not use the power cord for carrying other
objects!
•
Do not bend the power cord and do not pull it
against sharp edges; do not place the power cord
on hot surfaces or open fire!
PACKING
•
After unpacking the appliance, check if its contents
are intact and if it has not been damaged during
transportation! In case a damage or incomplete
delivery is found, contact your authorized retailer!
•
Do not dispose of the original packing box! It could
be used for storage and transportation purposes in
order to avoid damages during transportation!
•
Disposal of packing material should be done in the
appropriate way! Children must be prevented from
playing with polyethylene bags!
English
INSTALLATION INSTRUCTIONS
•
This panel heater is designed to be used indoors,
mounted on a wall.
Important: In premises bigger than 45 m
recommended to use a combination of 2 or more
panel heaters.
С).
о •
Do not position the panel heater under a power
socket or electricity connection box.
•
DO NOT install/operate the panel heater:
in places where a draught is present, which
1.
could influence the control settings;
right under a power socket;
2.
in "Volume 1" for bathrooms;
3.
in "Volume 2" if the control board can be
4.
reached by a person who is in a shower or in a
bathtub;
•
for the wall-mounting of the panel heater, only
the wall braces must be used which are delivered
together with the appliance. When installing the
panel heater, minimum safe distances must be
observed
•
First of all, remove the wall braces from the back of
the appliance body. Unscrew the two screws which
are positioned at the upper part of the two vertical
bars of the wall braces. Then pull the upper part of
the bar by pressing strongly the two upper parts
which are inserted in the back of the body.
, it is
3
Operation and Storage Manual
EN
3