Troubleshooting - Azusa MIK0126 Bedienungsanleitung

OWNER'S MANUAL
III. Instruction of use:
1. Connect antenna to antenna sockets at the back of the receiver. Make sure the antennas are
positioned upright.
2. Connect the receiver to AC power mains by power cable.
3. When connecting mixer or amplifier, please connect the balance or mix output by cable to
mixer or amplifier.
4. Insert batteries into microphone battery compartment. Make sure to close the battery
compartment before use. Always turn off the microphone before replacing batteries.
5. Turn the receiver on, by pushing in the power button.
6. Turn the microphone on, by sliding the switch to the side.
IV. Troubleshooting:
PROBLEM
No sound.
The receiver has noise; The
receiving distance is too short.
Adjust the squelch threshold.
Distorted sound.
Cannot adapt to the musical
instrument.
STATES
• The power indicator of the
receiver is off.
• The RF indicator of the
receiver is off.
• The RF indicator is on and
the AF indicator is off.
• The RF and AF indicators
are on.
• The RF and AF indicators of
the receiving are flashing.
• The RF and AF indicators
are on.
• The indicator of the
transmitter is on.
• The RF and AF indicators
are on.
MIK0126

TROUBLESHOOTING

• Check the power connection
of the receiver.
• The transmitter' s power
switch should be in the "ON"
position.
• Check the polarity of the
batteries in the transmitter.
• Replace the batteries if
necessary
• Check if the channel of the
transmitter is the same with
the receiver.
• Adjust the volume switch on
the receiver.
• Check the audio output line
connecting the receiver and
the amplifier.
• Check the settings of the
amplifier.
• There is frequency
interference; change the
channel. For example:
change the CH1 to CH10.
• Adjust the volume of the
receiver to a suitable volume.
• Replace the battery.
• Adjust the receiver's volume
control to make them
compatible.
EN
9