Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1
Connect the device via the enclosed mains cable to a grounded mains socket. Thus the unit is switched
on.
2
To switch off the unit, disconnect the power plug.
3
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
Power supply of further devices
The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with P-Con plugs are available as accessories. In this manner, up to 8 devices can be linked at
230/240 input voltage and up to 4 devices at 110/115 input voltage.
OPERATION
After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.
Stand-alone mode
In the stand-alone mode, the device can be used without controller. Disconnect the device from the
controller.
Operating buttons
MENU
ENTER
UP
DOWN
Activates and exits the main menu
Activates a value to be modified or saves a value when modifying.
Selects menu items
Selects menu items
29/40
Connect the first device in
the chain to the computer's
network
card
(optionally
through a network switch)
with a network cable.
If needed, cables up to 100
meters long may be used
(point-to-point connection
provided). Different lengths
are available as accessory.
Please
refer
to
instructions
under
Structure.
00115891, Version 1.0
the
Menu
Werbung
Inhaltsverzeichnis
