Changing To The Parameter Level; Changing The Temperature Display Between °C And °F - Honeywell PTI-610 Einbau- Und Bedienungsanleitung

7.6 Changing to the parameter level

Behind the front foil of the temperature display device there are 3 keys which are used within the
parameter level.
The keys are protected against maloperation
• Deactivate key lock
press + and - key approx. 5 s at the same time until "Pon" blinks briefly at the display.
• Activate key lock
press + and - key approx. 5 s at the same time until "PoF" blinks briefly at the display.
14
GB
To change to the parameter level press SET for 5 s.
Current value is displayed.
Here: parameter 1 has the value 0.
If no further key is pressed the display returns to the temperature
display after 15 s.
To change to the next parameter press SET.
Sensor line-up
Current value is displayed for parameter 19 (here value 0).
If no further key is pressed the display returns to the temperature
display after 15 s.
• With the + key a sensor line-up takes place in 1 K steps
upwards.
• With the - key a sensor line-up takes place in 1 K steps
downwards.
The selected value is stored by pressing the SET key. Display
blinks briefly.
Changing the temperature display unit
Current value is displayed for parameter 22 (here value 0).
If no further key is pressed the display returns to the temperature
display after 15 s
• Changing between the displayed units using the keys
+ and -
• 0 = display in °C
• I = display in °F
The selected value is imported by pressing the SET key. To
change to the next parameter press SET. Display blinks briefly.
Subject to change without notice • MU1H1928GE23 R0106