Farmcomp OLLI 30B Gebrauchsanweisung Seite 16

Olli 30B and 70B
These two models can be powered with 9V dry battery or 12V rechargeable
battery. When using the 9V dry battery, place the 9V battery inside the battery
housing and connect the battery wires on connectors on top of the energizer to
connectors marked as 9 V connectors. Connect the red wire to connector marked
with (+) and black wire with connector marked with (-).
When using 12 V rechargeable battery with Olli 30B and 70B connect it to
energizer with connecting cable delivered together with the energizer. Connect
the battery cable to short connector cable coming out from energizer housing and
being marked as a connector for 12 V battery. Connect the other end of the
battery cable with battery so that red connector is connected with (+) connector
and black with (–) connector.
12V connection in Olli 30B and 70B have been equipped with deep discharge
protection which protects the battery.
After you have connected either 9 V dry battery or 12 V rechargeable battery,
place the lid and handle over the housing. Handle locks the lid and housing
together.
Olli 50S
Instructions for getting Olli 50S ready for use you find from point 8 onwards.
Olli 160B
This fence energizer model can only be powered with 12 V rechargeable battery.
Connect the battery cable to 12V battery so that you connect the red connector
with (+) connector and black with (–) connector.
If you are using 12 V rechargeable battery, please take into account safety
instructions about placing and using 12 V batteries given by battery
manufacturers.
Place the energizer on upright position, connectors facing down, on a firm ground
so that it can not be reached by the animals in the fence. It's recommented that
you cover the energizer agains rain, snow and direct sun light.
4. Connecting the energiser to the fence
When the fence is ready for use, connect the energiser to the fence wire with the
fence connector wire that is included in the delivery. Connect the connector cable
to the fence wire and tighten the screws properly to ensure a good electrical
connection.
Connect the other end of the fence connecting cable to the red connector marked
with symbol in the energizer. In the same way you connect the grounding of
the energizer to the black connector marked with symbol in the energizer.