Damage; Controls; Drain And Overflow Fittings; Troubleshooting Support - Duravit Jet-System E Bedienungsanleitung

cleaning and for removing stubborn spots.
> Remove extensive soiling with warm water and a liquid detergent, dish washer
liquid or soap suds.

Damage

> Remove scratches and other surface damage with the Duravit Acrylic Surface
Maintenance and Repair Set (ID No. 790302 00 0 00 0000).
7.3

Controls

> Clean the controls with a soft, damp cloth.
7.4 Drain and overflow fittings
> Clean the drain and overflow fittings with a soft, damp cloth.

8. Troubleshooting support

CAUTION!
The whirlpool tub may only be repaired by qualified plumbers and electricians.
Problem
Foaming
Whirl system won't
start?
Potential cause
Soap or shampoo in the
bathwater.
Water level too low.
Mains switch switched off.
Mains fuse is switched off.
Ground-faultswitch (RCD) or
circuit breaker has tripped.
Solution
>
Switch off the whirlpool
system.
>
Fill the tub with fresh water.
>
Add water until the water
level is about 5 cm above the
uppermost nozzle.
>
Switch on at mains.
>
Switch on mains circuit
breaker.
>
Disconnect tub from mains.
>
Call Customer Service.
31