Rain Cover - Chicco LITE WAY Gebrauchsanleitung

HOW TO REMOVE THE FABRIC COVER
The fabric cover of the stroller can be removed.
20. To remove the fabric cover, raise the leg rest (diag. 20A).
Unfasten the buckles (diag. 20B) and the press studs located
on the seat (diag. 20C); remove the fabric cover, taking care to
slide the safety harness through the appropriate hole.
21. Unfasten the press studs located on the rear tubes of the
stroller, as shown in diagram 21A. Unfasten the press stud C and
remove the two hooks D and E, located under the fabric panel
on the side of the stroller (diag. 21B). Lastly, remove the fabric
cover from the backrest, pulling it in an upward direction.
To fit the fabric cover to the stroller, carry out the following
operations.
22. Fit the fabric cover on the backrest of the stroller.
23. Fasten the two hooks, D and E, and the press stud C, as
shown in diagram 22.
24. Fix the two fabric panels to the rear tubes with the press
studs, as shown in diagram 23.
25. Fasten the press studs (diag. 24A). Fit the fabric cover to
the leg rest, then fasten the buckles (diag. 24B -24C).
Warning: regularly check the tension of the strap located under
the seat (diag. 24D).
ACCESSORIES
WARNING: The accessories described below may not be
available for some versions of this product.
Please read carefully the instructions on the accessories
available for the model purchased.
STORAGE BASKET
The stroller may come with a storage basket.
26. Fit the storage basket, sliding the straps around the tubes
of the stroller and fastening the press studs in the positions
shown in diag. 25.
Warning: Do not overload the storage basket. Maximum
weight 3 Kg.

RAIN COVER

The stroller may come with a rain cover.
27. To fit the rain cover, fasten the straps around the stroller's frame,
in the positions shown in diagram 26. After use, if the rain cover is
wet, let it dry in the air before folding the rain cover to store it.
WARNING: Be extremely careful when using the rain cover.
WARNING: Do not use the rain cover if the stroller is not fitted
with the hood or sun canopy to prevent the risk of suffocation.
To prevent the risk of suffocation, never leave the stroller under
the sun with the rain cover fitted to it.
FLEECE FOOTMUFF
Some versions have a fleece footmuff, which is ideal in cold weather.
28. Fit the fleece footmuff as shown in diagram 27, fastening
the press studs in the positions shown.
29. The upper part of the fleece footmuff has a comfortable
hood, that can be opened and closed with the velcro (diag. 28).
30. The footmuff has holes that allow you to slide through the
safety harness when you use the footmuff (diag. 29).
WARNING: Always use the fleece footmuff with the safety
harness inserted through the appropriate holes.
LEGCOVER
31. The footmuff can be used as a legcover by opening the zip
and removing the lower part in fleece (diag. 30).
32. To fit the legcover, fasten the clips, fastening the straps around
the stroller's tubes, in the positions shown in diagram 31.
BUMPER BAR
33. To remove the bumper bar, press the two buttons found on
the side of the bar (diagram 32) and pull the bar towards you.
Open one side of the bumper bar only to accommodate the
child in the stroller more easily.
34.To reattach the bumber bar to the frame, insert the two pla-
stic ends of the bumper bar in the plastic supports, as shown
in (figure 33).
WARNING: Always restrain the child using the safety harness.
The bumper bar is NOT a child restraint device.
WARNING: Do not use the bumper bar to lift the product up.
Important Note: The pictures and instructions contained in
the booklet refer to the complete stroller model. Some of the
components and functions described here may vary according
to the model purchased.
18
E
AV
IM
CI
AT
NA
EL
DE
AL
AD
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•