Troubleshooting Guide - Braun CareStyle 7 Bedienungsanleitung

Troubleshooting guide

PROBLEM
The appliance does not
switch on.
Steam comes out under the
base unit.
There are some water drops
from the holes in the bottom
of the soleplate.
Brown coloured fluid leaks
from the soleplate.
The first time the appliance
is turned on, you notice
smoke or smell.
The appliance emits an
intermittent noise
associated with vibrations.
The appliance emits a
continuous noise
associated with vibrations.
The cleaning valve is difficult
to unscrew.
After refilling the water tank,
the light does not reset.
All LEDs are flashing.
Steam icon is permanently
on, but there is no steam
emission from the soleplate.
Subject to change without notice.
Please do not dispose the product in the household waste at the end of its useful life. Disposal can
take place at a Braun Service Centre or at appropriate collection points provided in your country
DLB251960_Use_Instruction_IS_7043_7044_7055_7056_INT_5712811851.indb 15
CAUSE
The appliance is not plugged
into a mains socket.
The "max" pressure safety
system has opened.
Water has condensed inside the
tubes because steam is being
used for the first time, or has not
been used for some time.
Chemical water softeners or
additives have been poured into
the water tank.
Some parts have been treated
with sealer/lubricant which
evaporates the first time the iron
heats up.
Water is being pumped into the
boiler.
System error.
Lime scale has made the
cleaning valve difficult to open.
The water float does not work
appropriately.
The water tank is not positioned
correctly.
System error.
Water tank float is locked or the
water tank is not correctly
inserted.
REMEDY
Make sure the appliance is correctly connected and press
the On/Off button.
Turn the appliance off immediately and contact an
authorised Braun Customer Service.
Press the steam button several times away from the
ironing board. This will eliminate cold water from the steam
circuit.
Never pour products into the water tank. Clean the
soleplate with a damp cloth and rinse the boiler.
This is normal and will stop when you have used the iron a
few times. If the smoke/smell is still present after turning
off the appliance, contact an authorised Braun Customer
Service.
This is normal and no action is needed.
Unplug the appliance from the mains and contact an
authorised Braun Customer Service.
Turn the cap forcefully. To avoid the problem, rinse system
frequently.
Empty the water tank, rinse out and refill.
Position the water tank correctly.
Unplug the appliance, plug it in again and press On/Off
button. If this problem is still present, turn the appliance off
immediately, unplug and contact an authorised Braun
Customer Service.
• Turn off and unplug the appliance.
• Remove and empty the water tank, rinse out and refill.
• Insert the water tank. Switch on the appliance and wait
until the device is ready to use.
• Press the steam button and wait until steam comes out.
• Keep the steam button pressed for 10 seconds of
steam emission then release the steam button.
15
04.11.16 11:54