Mold Warning Mode; C/°F Toggle; Automatic Power-Off - Berner 219048 Bedienungsanleitung

Mold Warning Mode

Mold warning mode compares the surface temperature with the dew point temperature. Dew
point temperature is calculated using the ambient temperature and the relative humidity. If the
temperature difference is small enough, the LED above the display will change from green to
either yellow or red to indicate the possible presence of mold.

To activate mold warning mode, press the

Point the instrument at the object and hold down the trigger. The laser pointers will activate
showing the area in which the infrared sensor can see.

The display will show the current surface temperature
measurement spot, ambient temperature
dew point temperature
current measurement.

The LED above the display will indicate the possible presence of mold:
Green: High temperature difference. No risk of mold detected.
►
Yellow: Medium temperature difference. Possible mold risk present. Check again at a later
►
time to verify.
Red: Low temperature difference. High risk of mold detected. The display will flash the
►
appropriate measurement that may be the cause.
Reduce the humidity or increase the ambient temperature if high risk of mold is
detected.
The instrument cannot detect mold spores. The instrument only gives an indication
that mold formation is possible at the given location.
°C/°F toggle
To switch between Celsius and Fahrenheit, hold the

Automatic power-off

After approx. 25 s from releasing the trigger, the instrument will automatically turn itself off.
button to enter mold warning mode.
, relative humidity
. After releasing the trigger the display will hold the
24
of the object within the
button for approx. 3 seconds.
and