Seite 3
Betrieb / Operation / D'exploitation Die benötigten Schrauben sind den jeweiligen Bauteilen in kleinen Tüten beigefügt. Schrauben, die für den weiteren Zusammenbau nicht mehr benötigt werden, bitte wieder zurück in den Beutel legen, aus dem sie genommen wurden. Somit entsteht beim Zusammenbau weiterer Komponenten kein Durcheinander! The required screws are attached to the respective compo- nents in small bags.
Seite 4
Front Suspension 125000497 125000499 125000516 125000455 125000455 2.3 E-ring ………………………4 125000455 125000455 3x34.5 Hinge pin front inner 125000499 ………………………2 Front Suspension 125000458 125000498 125000407 125000509 125000481 M3x15 Screw …………4 125000458 Ball stud-Long 125000481 (M3x15) …………………2 Assemble both Left and Right Assemble both Left and Right...
Seite 9
Rear Chassis 125000480 (M3x12) 125000480 M3x12 Screw …………4 Motor Mount 125000480 (M3x10) (M3x27) Screw Cement 125000480 M3x10 Screw ……………1 125000480 M3x27 Screw ……3 Apply threadlocker(screw cement) Screw Cement...
Seite 10
Spur Gear 125000482 M4 Flanged Nylon Nut 125000438 125000438 ………………1 T02211 5x7 Top shaft spacer ……………………1 125000438 125000439 125000437 125000437 125000488 125000482 125000437 Motor Motor Motor Tighten the screws with one sheet of paper 125000521 M3x3 Screw inserted between both gears. ……………………1 125000481 M3x8 Screw 125000481...
Seite 12
Rear Suspension 125000496 125000456 125000456 125000496 125000456 125000456 2.3 E-ring 3.1x6x1 Plastic Washer 3x30.5 Hinge pin Rear outer …………4 ………………………2 …………2 125000456 Rear Suspension 125000512 4.8mm Ball End(Long) Right Upper approx.35mm …………4 125000512 125000512 125000518 3x54 Turnbuckle 125000518 …………2 Rear Suspension Assemble both Left and Right Assemble both Left and Right Ture-to -scale diagram...
Seite 13
Shock Absorber Front-Short Rear-Short 125000524 125000463 / 125000464 2.3 E-ring 125000523 125000468 ………………………8 Put a little oil 125000468 125000467 Shock Piston 125000468 (2.8x1.9) 125000468 Put a little oil 125000468 (2.8x1.9) ………………4 (3x1mm) 125000464 125000468 125000463 125000468 (3x1mm) (2.8x1.9) 125000468 2.8x1.9 O-ring 125000468 125000524 125000467...
Seite 14
Shock Absorber Front-Short for adjusting the spring tension Compress the spring and install 125000523 125000514 125000469 (Short) 125000524 125000514 125000470 …………4 (Long) Rear-Short Front Suspension 125000482 (M3) 125000480 (M3x15) 125000482 M3 Nylon Nut ………………2 125000480 M3x15 Screw ………2 Assemble as many times as specified Assemble both Left and Right Assemble both Left and Right...
Seite 15
Rear Suspension 125000482 (M3) 125000482 M3 Nylon Nut ………………2 125000480 125000480 M3x15 Screw (M3x15) ………2 Front Suspension 125000480 (M3x10) 125000480 (M3x10) 125000480 M3x10 Screw ……………6 Assemble both Left and Right ?装左和右...
Seite 17
Receiver / ESC 125000485 Antenna pipe set cover Receiver M3x3 Screw Antenna pipe 125000485 Double-sided Tape 125000484 Battery Battery ?池 ?池 If using loose battery cells, Please put the battery panel conversely. 125000484 Small clip ……………4 Must be purchased separately Must be purchased separately...
Seite 18
Wing 125000484 125000484 Small clip ……………2 125000508 Tyre 125000472 125000473 Rear Front 125000473 (Sponge) 125000472 (Sponge) Assemble as many times as specified...
Seite 19
Tyre Rear Front Front After fitting wheels to tyres,apply instant glue as shown Tyre 125000482 M4 Flanged Nylon Nut ……………4 125000482 Assemble as many times as specified Assemble both Left and Right Assemble both Left and Right...
Seite 20
Tyre Tyre 125000484 T02086 Small clip ……………3 Assemble as many times as specified...
Seite 21
125001107/08 125001109/10 125001111 125001112 125001113 3pcs Rear arm mount-F Wing green / Wing blue Rear chassis plate Main Chassis plate Rear arm mount-R Body green / Body blue 125001114 125001115 125001116 125001117 125001118 Rear shock tower 1pcs 1pcs Motor plate 1pcs Motor Mount Column Differential-L...
Seite 22
125000512 125000513 125000514 125000431 125000432 Below Spring mount end 4.8 Ball End-Long 5.8 Ball End Rear rim Front rim 4.8 Ball End-Short M3x10 Screw 125000433 125000434 125000516 125000437 125000438 Hexagonal 1.0 Servo spacer 1.5 Servo spacer 2x9.8 Pin Slipper pad Slipper hub Front hinge pin barce 125000439...
Seite 23
125000462 125000463 125000464 125000523 Shock Absorber upper cover-Plastic 8x1 O-ring 3x51 Rear Shock Absorber Shaft 3x42.5 Front Shock Absorber Shaft 2.3 E-ring 5mm Plastic Ball stud 2.3 E-ring Shock Absorber Front damper case top Spring mount end below cover-Plastic 125000524 125000467 125000468 125000640...
Seite 24
125000484 125000485 125000307 Antenna pipe set cover Small clip Double-sided tape Antenna pipe set C-Type-Holder 25 Degree - R C-Type-Holder 25 Degree - L 125000314 125000309 125000316 M3x3 M2x5 Screw Hex mount 5.1x8x0.2 Washer Front arm mount 1Set C-Type-Holder 30 Degree - L C-Type-Holder 30 Degree - R 125000310 125000311...
Seite 25
Driver Track / City Event Date Conditions Low traction Med traction Smooth Bumpy Grass Soft dirt Hard soil High traction Sandy Dusty Clay Other Front Suspension Front Shocks Shock Mounting&Camber link Toe-in (+)/Out (-) ° Bump Steep Spacer Spring(color) Caster Black 25°...
Seite 26
Service: ANSMANN AG Division Racing Abt. Service Industriestr. 10 97959 Assamstadt Tel.: +49 (0) 6294 4204 34 Fax.: +49 (0) 6294 4204 47 ANSMANN AG DIVISION RACING Thomas-Mann-Str.63 D-90471 Nuernberg Germany Tel.: +49 (0) 911 817 44 0 Fax.: +49 (0) 911 817 44 22 email: info@ansmann-racing.com...