Peg Perego aria shopper Gebrauchsanleitung Seite 14

EN_English
WARNING
IMPORTANT: read these instructions carefully and
keep them for future use. The child's safety could be
at risk if these instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This item is approved for children from 6 months up
to a weight of 15 kg in the seat.
_ This seat unit is not suitable for children under 6
months.
_ This product is designed to be used with Ganciomatic
Peg-Perego products: "Primo Viaggio SL" (group 0+)
car seat, suitable for children from birth to 13 kg.
_ When used in combination with car seat (0+ group ),
this vehicle does not replace a cot or a bed.
Should your child need to sleep, then it should be
placed in a suitable pram body, cot or bed.
_ WARNING Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use.
Check that the Peg Perego Ganciomatic product are
correctly fixed to the item.
_ WARNING The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system. Always
use the five point harness. Always use the harness
crotch strap in combination with the waist strap.
_ WARNING Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_ WARNING To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING This product is not a toy. Do not let your
child play with this product
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support
the child's weight. It is not designed to keep the child
in the seat and does not substitute for the waist belt.
_ Do not load the baskets over 5Kg. Do not put weight
in the cup holder (if present) in excess of those
indicated on the cup holders themselves and never
hot drinks. Do not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
_ WARNING: This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING Do not add any mattress are not approved
by the manufacturer.
_ Do not use accessories which are not approved by
the manufacturer.
INSTRUCTIONS
1 OPENING: (fig_a) to open the stroller, release the two
connectors simultaneously, lift the handle upwards
sharply (fig_b) and then push it down again until it
snaps into place (fig_c).
If the front clips do not fasten properly, push down on
the seat until they click into place.
Once the stroller is open, use the magnets to attach
the fabric on the sides of the seat to the armrests.
2 FITTING THE REAR WHEELS: To mount the rear wheel
unit, press button 1 all the way down (fig_a) while
pressing on the wheels until they click into place
(fig_b).
3 FITTING THE FRONT WHEELS: To mount the front
wheels, lower the lever (fig_a) and click the wheels
into place (fig_b).
4 BASKET: slide the basket under the seat in the
direction as shown and slip the front loops over the
two hooks on the frame (arrow 1). Slip the basket's
rear slit over the handle of the support tube (arrow 2)
and slide the basket over the support tube (arrow 3),
fastening the two buttons at the back and the two on
the side (arrow 4). Finally fasten the two loops at the
back onto the buttons on the frame (arrow 5).
5 FITTING THE FRONT BAR: Attach the front bar as
shown in the figure.
6 HOOD: To attach the hood, insert the tabs into the
notches (fig_a) and button the hood to the rear of the
backrest (fig_b).
7 The hood can be rotated into several positions (fig_a).
To remove the hood, press the side buttons while
lifting the hood off (fig_b).
8 BRAKE: Press down on the brake lever situated on the
rear wheel unit to set the brake on the stroller. Lift the
lever to release the brake. Always set the brake when
the stroller is at a standstill.
9 FIVE POINT SAFETY HARNESS: To fasten it, push the
two waist strap buckles (with the shoulder straps
attached – arrow_a) into the leg divider until they click
into place (arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c) and pull
the waist straps out (arrow_d).
10 To tighten the waist strap, pull on both sides in the
direction of the arrow (arrow_a). To loosen it, move it
in the opposite direction.
11 To adjust the height, slip the belts through the eyelet
in the fabric and position them in the most suitable
eyelet.
12 ADJUSTING THE BACKREST: to lower the backrest press
the clip (fig_a) and the backrest will move down to the
desired position. To raise the backrest, press the clip
and lift the backrest to the desired height.(fig_b).
13 SWIVELLING WHEELS: Lower the lever (fig_a) to allow
the front wheels to swivel. Lift the lever for fixed
wheels (fig_b).
14 FRONT BAR: the front bar can be opened to make it
easier for an older child to get in and out. To open on
one side only, press one of the two buttons (1 or 2)
and rotate it upwards (fig_a). To remove it, press both
buttons (1 and 2) and simultaneously pull it upwards
(fig_b).
15 REMOVING THE WHEELS: To remove the rear wheels,
press the button (fig_a) and at the same time push
the wheels down until they come off (fig_b).
16 CLOSING: before closing the stoller, close the hood
if it is fitted (fig_a). To close the stroller, lift the two
levers on the handle (fig_a) and rotate the handle
forwards until it clicks into position (fig_b).
17 Push the backrest and the hood towards the stroller
- 14 -