AEG BMG 4907 Bedienungsanleitung Seite 52

AEG_BMG_4907_Bed_An_80x110.qxd 01.03.2005 12:18 Uhr Se
GB
Attention: Batteries do not belong in your usual household rubbish. Please
dispose of old batteries at proper collecting points or at the competent dea-
ler. Never throw batteries into a fire.
Operation with mains adaptor
You can optionally operate the device over a mains adaptor (not included).
1. Put the plug of the mains adaptor into a properly installed shockproof
2. Connect the device to the mains adaptor by putting the plug of the mains
3. When using a mains adaptor (6V DC) take care to apply the correct polari-
A. Wrap the cuff around the upper arm.
1. Open the Velcro fastener and pull to open the cuff (6).
2. Lead your arm through the cuff and pull the cuff
B. Pull the cuff tight around the upper arm.
1. Do not pull on the cuff with exaggerated force.
2. Do not pull the cuff too tight, leave a gap of about
Correct body position for measuring
To receive best possible measuring results make sure that the cuff is held on
the same level as your heart. If the cuff is held in a position above or below
the heart this may lead to deviations from the exact value.
Measuring blood pressure in sitting position
1. Rest your elbow on a table or other surface
2. Position your arm on the rest in a way that
3. Relax your arm; the palm of your hand must
Description of the symbols on the display
The
hes as soon as the pulse has been detected. Do not move or talk during the
measuring cycle.
52
Downloaded from www.Manualslib.com
socket (230V, 50Hz).
adaptor into the 6V DC jack (8) of the device.
sation according to the labels on the device
up to a position 1-2 cm above your elbow.
Suitable for a perimeter of the upper arm of about
22-34 cm.
the width of a finger.
(as, e.g., a bag).
makes sure that the cuff is on the same level
with your heart.
point upwards.
♥
symbol is shown on the display during the measuring cycle and flas-
manuals search engine
_(•_⊕.