Disassembly; Storage/Care; Disposal; Technical Data - Tapkey SMART LOCK Bedienungsanleitung

Set the protective cap in place and tighten
the Torx screws (Torx T10) by hand.
Fig. 29: Fitting the protective cap

DISASSEMBLY

Disassembly is basically carried out in the reverse
order of installation.



26
Caution: Avoid electrostatic charges prior to
the (dis)assembly of electronic components
or touch a conductive, grounded object (e.g.
water pipe, heating) beforehand to remove
electrostatic charge from your body. Never
touch the electronics components with your
fingers.
Caution: Material damage due to improper
storage. If you store the Tapkey Smart Lock for
an extended period prior to installation, store
all the components in their original packaging
in a dry, dust-free location.
Caution! If you remove the electronic knob,
always make sure you disconnect the battery
connector first and leave it in this state for
storage.

STORAGE/CARE

If you store the Tapkey Smart Lock for an extended
period prior to installation or after use, store it in
their original packaging in a dry, dust-free location in
room temperature.

Please note: Because the Tapkey Smart Lock
is delivered with the battery inserted, you
should not store the cylinder any longer than
necessary.

Caution: Material damage can be caused by
the use of aggressive detergents. Do not use
aggressive detergents, graphite or oil. Clean
the housing and locking media only using a
soft, damp leather cloth without detergent.

DISPOSAL

Please note that the Tapkey Smart Lock consists in
part of electronic components that require special
disposal. When disposing of the Tapkey Smart Lock,
please always comply with all local environmental
protection regulations.
You can return the components of your Tapkey Smart
Lock to the manufacturer in the original packaging.

TECHNICAL DATA


Please note: You can find the current
Technical Datasheets on the website of
Tapkey GmbH: www.tapkey.com
27